MEMS-based LC tank with extended tuning range for low phase-noise VCO

Abstract

This paper presents the modeling, manufacturing, and testing of a micro-electromechanical system (MEMS)-based LC tank resonator suitable for low phase-noise voltage-controlled oscillators (VCOs). The device is based on a variable MEMS varactor in series with an inductive coplanar waveguide line. Two additional parallel stubs controlled by two ohmic MEMS switches have been introduced in order to increase the resonator tunability. The device was fabricated using the FBK-irst MEMS process on high resistivity (HR) silicon substrate. Samples were manufactured with and without a 0-level quartz cap. The radio frequency characterization of the devices without 0-level cap has shown a continuous tuning range of 11.7% and a quality factor in the range of 33–38. The repeatability was also tested on four samples and the continuous tuning is 11.7 ± 2%. Experimental results on the device with a 0-level cap, show a frequency downshift of about 200 MHz and a degradation of the quality factor of about 20%. This is, most likely, due to the polymeric sealing ring as well as to a contamination of the ohmic contacts introduced by the capping procedure. A preliminary design of a MEMS-based VCO was performed using Advanced Design System and a hardwired prototype was fabricated on Surface Mount Technology on RO4350 laminate. The prototype was tested resulting in a resonance frequency of 5 GHz with a phase noise of −105 and −126 dBc at 100 KHz and 1 MHz, respectively, and a measured output power of −1 dBm.

RF-MEMS Switches Designed for High-Performance Uniplanar Microwave and mm-Wave Circuits

“…Basic components (like low-loss CPW, microstrip line and slotline, ohmic [41,42] and capacitive [43,44] switches, variable capacitors and inductors) can be integrated in complex reconfigurable RF circuits. Many kinds of devices were produced, mainly for space and communication application, like switching matrices [45,46], tunable and switchable phase shifters [47], reconfigurable antennas, impedance matching networks [48], VCOs [49,50], and tunable filters. Depending on the used substrate, highresistivity silicon (<40 GHz), or fused quartz (>40 GHz), the working frequency range spans from sub-GHz up to more than 100 GHz.…”

MEMS Sensors - Design and Application

“…Basic components (like low-loss CPW, microstrip line and slotline, ohmic [41,42] and capacitive [43,44] switches, variable capacitors and inductors) can be integrated in complex reconigurable RF circuits. Many kinds of devices were produced, mainly for space and communication application, like switching matrices [45,46], tunable and switchable phase shifters [47], reconigurable antennas, impedance matching networks [48], VCOs [49,50], and tunable ilters. Depending on the used substrate, highresistivity silicon (<40 GHz), or fused quarz (>40 GHz), the working frequency range spans from sub-GHz up to more than 100 GHz.…”

A modified Jerusalem microstrip filter and its complementary for low phase noise X-band oscillator

“…There are many articles about the application of wideband filters in LPNOs [33][34][35][36][37][38][39]. In [33], the LPNO and wideband VCO (WVCO) using microstrip combline filters are investigated.…”