Mesoporous materials for antihydrogen production

Abstract

Antimatter is barely known by the chemist community and this article has the vocation to explain how antimatter, in particular antihydrogen, can be obtained, as well as to show how mesoporous materials could be used as a further improvement for the production of antimatter at very low temperatures (below 1 K). The first experiments with mesoporous materials highlighted in this review show very promising and exciting results. Mesoporous materials such as mesoporous silicon, mesoporous material films, pellets of MCM-41 and silica aerogel show remarkable features for antihydrogen formation. Yet, the characteristics for the best future mesoporous materials (e.g. pore sizes, pore connectivity, shape, surface chemistry) remain to be clearly identified. For now among the best candidates are pellets of MCM-41 and aerogel with pore sizes between 10 and 30 nm, possessing hydrophobic patches on their surface to avoid ice formation at low temperature. From a fundamental standpoint, antimatter experiments could help to shed light on open issues, such as the apparent asymmetry between matter and antimatter in our universe and the gravitational behaviour of antimatter. To this purpose, basic studies on antimatter are necessary and a convenient production of antimatter is required. It is exactly where mesoporous materials could be very useful.

Spray-combustion synthesis: Efficient solution route to high-performance oxide transistors

“…4C clearly indicates that, in these amorphous films, S r values depend mainly on porosity. Thus, higher S r values in the IGZO films correspond to higher Ps formation (para-Ps and ortho-Ps pick-off that annihilates in two γ-rays) (48). Quantitative evaluation is provided by fitting the data S r evolutions in Fig.…”

Positronium as a probe of small free volumes in crystals, polymers and porous media

“…Tomasz Goworek 6 pores thermalizes and diffuses to outside [18]. The efficiency of e + -Ps transformation exceeds 50%.…”

New Porosimetric Method Based on the 3γ Annihilation Rate. Applications to Materials Science and Medical Imaging

“…However, it can be useful to compare 3γ fraction in a group of investigated materials. The determination of the 3γ fraction was widely applied to investigate high porosity materials towards preparation targets in some experiments in order to elongate positronium survival time and its production amount [8][9][10]. In a wide group of organic materials containing small intermolecular voids with the size below 1 nm, determined o-Ps lifetime values are of an order of a few ns, while the intensity in most cases is in a range of 20-30%.…”