Microstructure and properties of Nb, V and N alloyed low magnetic hot rolled stainless steel plate

Dong, Jingbo; Li, Kun; Lixiang, Gao; Li, C.S.

doi:10.1007/s42864-022-00166-1

Cited by 9 publications

(2 citation statements)

References 34 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…[134][135][136] However, compared with gas adsorption and electrocatalytic reactions, the use of defect MOFs in sensor applications has received less attention. [136][137][138][139] In this review, we focus on the recent developments in using defective MOFs for optical and electrochemical sensors. The denition, advantages and creation of defectives are summarized.…”

Section: Introductionmentioning

confidence: 99%

Defect-containing metal–organic framework materials for sensor applications

An,

Chen,

Liang

et al. 2024

J. Mater. Chem. A

View full text Add to dashboard Cite

show abstract

Section: Introductionmentioning

confidence: 99%

Defect-containing metal–organic framework materials for sensor applications

An,

Chen,

Liang

et al. 2024

J. Mater. Chem. A

View full text Add to dashboard Cite

show abstract

“…However, a complete characterization of the recrystallization process by tracking microstructural evolution at specific plastic strains and annealing conditions is extremely tedious since a large amount of experimental data is required from the same experiment. The effects of rolling strain on the deformation microstructure and recrystallization behavior were mainly assessed using homogeneous materials [21,[24][25][26]. To some extent, such experiments were time-consuming and costly.…”

Section: Introductionmentioning

confidence: 99%

Microstructure and Texture Evolution of Hot-Rolled Mg-3Gd Alloy during Recrystallization

Han

Wang

Luo

et al. 2023

Metals

View full text Add to dashboard Cite

An Mg-3Gd (wt.%) sample with gradient rolling strains (ε = 0–0.55) was prepared using a wedge-shaped plate after one-pass hot rolling, allowing a high-throughput characterization of microstructure and texture over a wide strain range within one hot-rolled plate. The microstructure and texture evolutions were characterized as a function of rolling strain for the as-hot-rolled sample and as a function of annealing temperature for the subsequently annealed samples. The deformed microstructure showed a gradual change with increasing rolling strain, i.e., from a deformation twins-dominant structure in the low strain range of 0–0.20, to a shear bands-dominant structure in the higher strain range of 0.20–0.55. The recrystallization behavior during annealing showed a clear correlation between the recrystallization nucleation site and the deformed microstructure. However, a weak recrystallization texture with non-basal texture components was formed over almost the entire strain range. This work demonstrates a high-throughput experimental strategy using a wedge-shaped sample to investigate the effect of various processing parameters, such as strain and annealing temperature, on the evolution of microstructure, texture, and mechanical properties, which could accelerate the optimization of processing parameters and microstructural design.

show abstract