SummaryThis research proposes a novel low‐cost aperture coupled elliptic patch nanoantenna which works best when it has a stable radiation pattern and good gain. On the upper portion of the substratum, a cross‐shaped hole was additionally engraved from a metallic strip with a silver composition. Elliptical‐shaped silicon material is employed as a patch in this antenna design which is made on a substrate made of inexpensive glass epoxy. The silver substance makes up the nanometallic strip line at the substrate's base. A cross‐shaped hole has also been etched from a metallic strip with a silver composition on the upper section of the substrate. As the foam substrate to be used in between the feed and antenna substrates, Rohacell was adopted. A proposed simple cross‐shaped aperture enhanced the bandwidth of the planned antenna without degrading its radiation performance and is loaded on a proximity‐linked elliptical microstrip antenna. To achieve the highest coupling, the lowest back radiation, the least amount of spurious radiation, and good efficiency, the patch and feed line are positioned in the middle, at a right angle over the slot. The proposed antenna was simulated in HFSS, and optimum results were observed from the output. The results were evaluated based on radiation pattern, return loss, smith chart, radiation efficiency, and 3D polar plot for 300, 500, and 800 THz frequencies. Also, the impedance bandwidth, gain, and a number of bands were compared with other conventional methods and our proposed method proved to outperform the existing method in all aspects.