Monitoring the Microseismicity through a Dense Seismic Array and a Similarity Search Detection Technique: Application to the Gas-Storage Site of Collalto, North Italy

Abstract

Seismic monitoring in areas where induced earthquakes could occur is a challenging topic for seismologists due to generally very low signal to noise ratio. Therefore, the seismological com-munity is devoting several efforts to the development of high-quality networks around the areas where fluid injection and storage and geothermal activities take place, also following the national induced seismicity monitoring guidelines. The use of advanced data-mining strategy, such as template matching filters, auto-similarity search and deep-learning approaches is recently further fostering such a monitoring enhancing the seismic catalogues and lowering the magnitude of completeness of these areas. In this framework, we carried out an experiment where a small-aperture seismic array was installed around the gas reservoir of Collalto, in North Italy. The continuous velocimetric data, acquired for 25 days, were analysed through the application of the optimized auto-similarity search technique FAST. The array was conceived as a cost-effective network, aimed at integrating, right above the gas storage site, the permanent high-resolution Collalto Seismic Network. The analysis allowed to detect micro-events down to magnitude Ml=-0.4 within a distance of ~15km from the array. Our results confirmed that the system based on the array installation and the FAST data-analysis might contribute to lower the magnitude of completeness around the site of about 0.7.