On anomalous channelling effects in ion-implanted silicon

Mazzone, A. M.

doi:10.1080/09500838708203756

Cited by 10 publications

(1 citation statement)

References 10 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Although during implantation the sample was ti]ted 7 ~ from the surface normal to minimize channeling, some channeling can occur. By Monte Carlo simulation it has been shown that channeling is sustained by a nonvanishing divergency of the ion beam for a nominally random orientation of the target (18). The role of accidental channeling will be investigated by measuring atomic implantation profiles using SIMS or GaAs targets which have been amorphized prior to the sulfur implantation 9 It should also be noted that the present version of TRIM does not include crystalline structure, but an updated version will.…”

Section: Resultsmentioning

confidence: 99%

MeV S Implantation into GaAs

Thompson

Dietrich

1988

J. Electrochem. Soc.

View full text Add to dashboard Cite

The physical and electrical characteristics of MeV S implants into normalGaAs have been studied. The redistribution of the ion implanted S has been investigated using secondary ion mass spectroscopy and electrochemical capacitance‐voltage profiling. The redistribution of the implanted S has been greatly reduced when rapid thermal anneal, instead of furnace anneal, is employed for activation. The measured diffusion coefficient (using RTA) is 3.7×10−12 cm2/normals , which is comparable to that measured in furnace annealed samples. Hence the reduction in the redistribution is solely from a reduction of the time at temperature. The rapid thermal anneal temperature required for activation is dependent upon implantation dose. 950°C was adequate for activation of implants of 1.15 MeV S with fluences less than or equal to 5×1013/cm2 . In the case of 1.15 MeV S, 5×1014/cm2 , after an 1100°C, 10s anneal, the carrier profile showed incomplete activation and residual defects were observed using cross‐sectional transmission electron microscopy. Device quality buried layer and extended layer profiles have been produced and characterized.

show abstract

Section: Resultsmentioning

confidence: 99%