Partial discharge current pulses in SF₆and the effect of superposition of their radiometric measurement

Abstract

The practical advantages of employing non-contact radio frequency (RF) methods for detecting partial discharges (PDs) in high voltage equipment have led to significant effort being focused on the diagnosis of electrical plants using RF techniques. This has particularly been the case for gas insulated substations, which use sulphur hexafluoride (SF6) as an insulating medium. One of the most important challenges facing RF diagnostics is the problem of relating the RF emissions to some measure of severity of the PD. Previous work has established that the amplitude or energy of RF signals radiated from a PD source is strongly dependent on the rate of change of current in the PD pulse. In this paper, measurements of PD current pulses in SF6 are presented for a point-plane configuration using an extremely wide bandwidth (13 GHz) measurement system. By this means, PD pulse shapes have been recorded with better resolution than has previously been possible and rise times have been measured with a high degree of accuracy. The results show a considerable variation in pulse shape, with the minimum rise time measured being 35 ps. With this high time-domain resolution, we have been able to distinguish features within the PD pulses that will affect the energy of the radiated RF signal. In particular, the current pulses tend to occur in bursts of up to ten individual pulses in as little as 1 ns, which will excite multiple RF signals in rapid succession. The effect of superposition of RF waveforms has been investigated by studying the variation in detected RF energy with respect to the time delay between PD pulses. It was found that when two PDs occur within a short period (< 150 ns) the combined energy of the resulting RF pulse has the potential to vary by ±30% of that resulting from two equivalent PD pulses with a wider pulse spacing (≫ 150 ns). In terms of a practical monitoring system concerned with order-of-magnitude variations; this is not considered to pose a major problem for the RF technique.

Modeling of High-Frequency Current Transformer Based Partial Discharge Detection in High-Voltage Cables

“…To obtain "original" PD pulses that can be used as the source waveform to excite a PD event in the FDTD model, "direct measurement" of PD [28] in a cable was performed. The measurement setup is plotted in Fig.…”

A Novel Analytical Expressions Model for Corona Currents Based on Curve Fitting Method Using Artificial Neural Network

“…Investigation [14] indicates that these complex currents can achieve a significantly better match by higher order Gaussian functions compared with the Wanninger function and double exponential function. Based on the investigation, the BPNN method proposed in this paper will be used to fit this kind of complex corona currents, and a comparison with the multiple-order Gaussian function will be discussed.…”

“…The corona currents measured from discharge system II are all a damped oscillatory pulse in waveforms and can be treated as complex corona currents. According to [14], the order of the Gaussian functions was selected within 10th, and the fitting results are shown in Fig. 4.…”

PD current pulse waveforms of environmental friendly gases measured with SHF_PDPW system and the applicability of the UHF method

“…Experimental setup is basically same as the previous study [1] which was further expanded the frequency bandwidth of the original system constructed by A.J.Reid, et al [3]. PD current waveforms were measured with the SHF_PDPW system that enables us to measure the PD current waveform precisely up to the SHF band depending on the frequency band of the used oscilloscope and attenuator.…”