Radio Frequency Seeker Modelling and Seeker Filter Design

Abstract

Radio frequency seeker model, including receiver angle error noise modelling and filtering of noise from seeker measurement, is presented in this paper. The effects of eclipsing, radar cross section fluctuation, etc on seeker sight-line rate measurement are highlighted. The formulation for colour noise modelling of sight-line rate noise is derived based on the knowledge of seeker receiver angle error noise model. Two Kalman filter configurations for filtering of noise from seeker output have been considered in this paper, based on sight-line rate kinematics and noise characteristic. It has been observed from the simulation studies that sight-line rate signal varies slowly at higher interceptor-target ranges; with severe colour noise in sight line rate measurement, and therefore higher weightage for noise attenuation is beneficial in Kalman filter configuration. So, kinematic plus state augmentation for colour noise are considered for adequate filtering for higher interceptor-target ranges. Whereas for lower interceptor-target ranges, sight-line rate changes appreciably, which have been tracked by a simplified/modified spherical coordinate model, which uses knowledge of interceptor-target engagement dynamics. For both the filters, benefits of colour noise modelling and process model augmentation through coloured noise states, for filtering severe colour noise of seeker, has been demonstrated. Keywords: RF seeker models, seeker filters, sight-line rate, seeker models, seeker modelling filter design, colour noise modelling, radio frequency seeker model NOMENCLATURE RM,Interceptor-target range

A novel pulsed Doppler radar seeker modeling method used for closed loop trajectory simulation

“…To be more specific, the two rate components perpendicular to the LOS are needed and to provide estimates of these quantities is the basic task of a seeker system. In [7], a tracking filter for use with bearing-only measurement data is presented. The implementation is based on the Modified Spherical Coordinate (MSC) method.…”

Reusable Modeling of Pulsed Doppler Radar Seeker for Coherent Video Signal Simulation

“…On the other hand, coherent video signal simulation can describe the process of wave transmission, propagation, back scattering, antenna receiving, receiver processing, digital signal processing and maybe following data processing [5,6], in a comprehensive way. This paper is dedicated to the design of reusable PDRS model for coherent video signal simulation.…”