Real time supervision for a hybrid renewable power system emulator

Abbes, Dhaker; Martinez, A.; Champenois, Gérard; Robyns, Benoît

doi:10.1016/j.simpat.2013.12.003

Cited by 28 publications

(12 citation statements)

References 12 publications

Supporting

Mentioning

Contrasting

Unclassified

Order By: Relevance

“…There are numerous kinds of MPPT algorithms for solar PV generators in the literature [24]. Out of all the MPPT algorithms, P&O is the most primary and prominent method.…”

Section: Control Design Of the Proposed Mppt Algorithmmentioning

confidence: 99%

“…Out of all the MPPT algorithms, P&O is the most primary and prominent method. In this work, we consider an enhanced P&O algorithm with adaptive increment-step [24]. Basic principle of this strategy is increment-step variation to converge quicker towards maximal power point (MPP) while reducing oscillations around.…”

Section: Control Design Of the Proposed Mppt Algorithmmentioning

confidence: 99%

See 1 more Smart Citation

New Optimal Control of Permanent Magnet DC Motor for Photovoltaic Wire Feeder Systems

Babes¹,

Boutaghane²,

Hamouda³

et al. 2020

JESA

View full text Add to dashboard Cite

This article aims to improve the permanent magnet DC (PMDC) motor performance for photovoltaic (PV) wire-feeder systems (PVWFSs) of arc welding machines. The considered technique is designed by direct speed control based on optimal Fractional-order Fuzzy PID FO-Fuzzy-PID controller. The purpose is to ensure optimal control of wire feed speed reference to reduce torque ripples and hence, the performance of the WFS is improved. The dynamic reaction of the proposed solar PVWFS relies upon the scaling factors of FO-Fuzzy-PID controller, which are optimized by using teaching-learning algorithm based on Particle Swarm Optimization (PSO) method. The maximum power point tracking (MPPT) is achieved using an intelligent FO-Fuzzy-PID current controller based Perturb and Observe (P&O) MPPT algorithm. The PVWFS system incorporating the proposed method is tested and compared with the conventional PID control scheme under different weather conditions. The simulation of the proposed system by MATLAB\SIMULINK is carried out. The simulation results indicate the effectiveness of the considered control strategy in terms of the reduction in torque oscillations, optimizing electrical power and wire feed speed.

show abstract

“…There are numerous kinds of MPPT algorithms for solar PV generators in the literature [24]. Out of all the MPPT algorithms, P&O is the most primary and prominent method.…”

Section: Control Design Of the Proposed Mppt Algorithmmentioning

confidence: 99%

Section: Control Design Of the Proposed Mppt Algorithmmentioning

confidence: 99%

New Optimal Control of Permanent Magnet DC Motor for Photovoltaic Wire Feeder Systems

Babes¹,

Boutaghane²,

Hamouda³

et al. 2020

JESA

View full text Add to dashboard Cite

show abstract

“…Therefore, the converter output voltage at the DC bus side is equal to 400 V and the converter input voltage is the batteries modulated voltage U mbat which is varied in the next voltage range [358V, 453V] according to the charging or discharging mode of BESS. 37…”

Section: Bess Modelmentioning

confidence: 99%

Power management and second-order sliding mode control for standalone hybrid wind energy with battery energy storage system

Krim

Abbes

Krim

et al. 2018

Proceedings of the Institution of Mechanical Engineers, Part I:

Self Cite

View full text Add to dashboard Cite

The purpose of this article is to provide a high performance control of a renewable distributed generator to guarantee an electric power quality and jointly reduce the mechanical stress despite any possible uncertainties such as the random nature of wind speed, the presence of parameters uncertainties, and external perturbations acting on the system (sudden load variation). The renewable distributed generator integrating a wind generator associated with a batteries module is considered as an energy storage device and a variable load. The proposed method is designed by a power management supervisor and a sliding mode control technique. First, the power management supervisor is used to monitor the power flows transferred between the different system devices depending on the load variation and on the intermittency of wind production. In fact, it enables to ensure the balance at the continuous, Direct Current (DC) bus between the powers supplied by the renewable distributed generator and those demanded by the load. In addition, it prevents batteries from exceeding its maximum or minimum state of charge (SOC bat) by keeping it at an acceptable level [30%, 90%]. Second, a second-order sliding mode control based on the super-twisting algorithm is suggested to control the two subsystems (generator side and load side converters). The main target of the first one is to extract the maximum wind power taking into account the parameter variations and the fluctuating nature of wind. The second one is to investigate a second-order sliding mode control of active and reactive load power quantities, which provides better results in terms of attenuation of the harmonics present in the load voltage and current while considering the sudden load variations. In addition, a proportional-integral controller is also designed and simulated to establish a comparison framework. According to the simulation results, the second-order sliding mode control successfully deals with the nonlinearity of the renewable distributed generator compared with the proportional-integral performance.

show abstract

“…According to the load demand and the geographical location, these hybrid systems are operated indifferent mode. The authors in [88] have implemented real-time integration of solar PV-wind-battery hybrid system to solve the challenges with respect to the dynamic variation of load consumption. Integration of solar photovoltaic (PV)-wind with energy storage and management system with optimizing model is discussed in [89].…”

Section: Hybrid Systemmentioning

confidence: 99%

A Bibliographical Survey on Integration of Hybrid Renewable Energy Sources with Diesel Generator and Storage System

Dharavath¹,

Raglend²,

Karthikeyan³

et al. 2018

JESTR

View full text Add to dashboard Cite

The power consumption has increased enormously due to the intervention of high end technology and it is necessary to meet this power demand. The power pushed into any electrical system should be highly reliable, secured with sufficient quantity and quality. One such solution is to bring reliable and flexible power by introducing Hybrid energy systems into the network. The main motivation of hybrid energy systems is to improve the delivery of power at the utilities and customer end. In this paper, a complete literature review is made on the integration of solar photovoltaic, wind and diesel generator with energy storage systems like hydrogen based fuel cells and batteries. This hybrid system reduces the operating time of diesel generator, save the fuel consumption and hence accomplishes the peak demand with diesel generator.

show abstract

Real time supervision for a hybrid renewable power system emulator

Cited by 28 publications

References 12 publications

New Optimal Control of Permanent Magnet DC Motor for Photovoltaic Wire Feeder Systems

New Optimal Control of Permanent Magnet DC Motor for Photovoltaic Wire Feeder Systems

Power management and second-order sliding mode control for standalone hybrid wind energy with battery energy storage system

A Bibliographical Survey on Integration of Hybrid Renewable Energy Sources with Diesel Generator and Storage System

Contact Info

Product

Resources

About