Single bit hybrid full adder cell by gate diffusion input and pass transistor logic technique

Goyal, Rishab; Sharma, Shubham

doi:10.1109/icaetgt.2017.8341452

Cited by 5 publications

(1 citation statement)

References 8 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Hybridization of various concepts of power reduction can be helpful in introducing a new low power technique for low nm technologies [22][23][24][25]. Full output voltage swing and less noise is required for efficient implementation of any digital circuit.…”

Section: Previous Contributionmentioning

confidence: 99%

Sleepy- Gate Diffusion Input (S-GDI) — Ultra Low Power Technique for Digital Design

Sharma*,

Sohal

2019

IJITEE

View full text Add to dashboard Cite

In this paper we propose a power efficient technique called Sleepy- Gate Diffusion Input (S-GDI) that can be used for efficient digital design at nano scale foundries. For area and power comparison, ten prior techniques are taken in to consideration and applied on XOR gate, 1-bit adder, 1-bit comparator and 4- bit up-down counter. All techniques are parametrically analyzed on 65nm technology. The proposed S-GDI technique has been observed power efficient as compared to Complementary CMOS technique (CCT), Complementary Pass Transistor Logic (CPTL), DCMOS (Differential CMOS), Differential Cascode Voltage Switch with Pass Gate Logic (DCVSPG), Energy Economized Pass Transistor Logic (EEPL), Lean Integration with Pass Transistors (LEAP), Push-Pull Pass Transistor Logic (PPL), Pass Transistor Logic (PTL), CMOS with Transmission Gate (TG) and Gate diffusion Input (GDI). As compared to GDI technique S-GDI is showing 96.20%, 93.65%, 97.88% and 98.22% power efficiency for XOR, 1-bit adder, 1-bit comparator and 4-bit up-down counter respectively. S-GDI is showing area efficiency of 17.16% and 28.1% for XOR, 41.26% and 53.89% for 1-bit adder, 7.6% and 21.76% for 1-bit comparator and 6.7% and 28% for up-down counter over EEPL and DCMOS technique respectively. Although other techniques except EEPL and DCMOS techniques are area efficient as compared to proposed technique but this is on the expense of higher total power dissipation. So, PDP (power delay products) of all considered techniques are also calculated on 65nm technology for both SUM and CARRY outputs of 1-bit adder. In both cases power delay product for S-GDI technique is very less as compared to all other considered technique. Due to efficiency of S-GDI in terms of considered parameters, this technique can be efficiently used for low power applications

show abstract

Section: Previous Contributionmentioning

confidence: 99%