Soil and water conservation effects of different tillage measures on phaeozems sloping farmland in northeast China

Yu, Peizhe; Yang, Tianqi; Zhang, Zhongxue; Zhou, Xin; Qi, Zhijuan; Yin, Zhihao; Li, Ao

doi:10.1002/ldr.5016

Cited by 3 publications

(1 citation statement)

References 43 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Contour ridging works by intercepting surface runoff and delaying runoff generation on slope farmland, thus controlling soil loss caused by runoff erosion. However, its drainage effectiveness is weaker than downslope ridging, making it prone to water accumulation [18]. Due to variations in the micro-topography of slope farmland, an unreasonable design might create low points along the contour ridges.…”

Section: Introductionmentioning

confidence: 99%

Evaluating the Accuracy of Contour Ridgeline Positioning for Soil Conservation in the Northeast Black Soil Region of China

Li,

Zhao,

Wang

et al. 2024

Sustainability

View full text Add to dashboard Cite

The Northeast black soil region is China’s vital commercial grain base. However, severe soil erosion on slope farmland poses a significant threat to this region’s sustainable agricultural productivity. The transition from traditional downslope ridging to contour ridging (briefly referred to as “contour ridging”) is one of the primary sustainable measures for preventing soil erosion on slope farmland. By integrating high-precision Digital Elevation Models (DEMs) and design standards, ArcMap can plan the orientation and position of contour ridgelines and estimate the reduction in soil erosion on slope farmland after implementing contour ridging. Therefore, the degree of discrepancy between the designed and implemented positions of the contour ridgelines directly affects the effectiveness of contour ridging and the precision in evaluating its impacts and benefits. This study aims to assess the position accuracy of contour ridgelines designed by ArcMap 10.5 (here after ArcMap) using high-precision DEMs obtained from unmanned aerial vehicles (UAV). For this purpose, three fields where contour ridging had already been implemented were selected in the Sanjiang Plain of Heilongjiang Province, China. CORS RTK was used to measure the XYZ coordinates of verification points along implemented ridges precisely. Those measured coordinates were compared with the designed ridgeline positions to analyze the positional discrepancies between the designed and implemented ridgelines. The results indicated the following: (1) The average slope gradient along contour ridgelines measured in the field (0.5~0.6°) was relatively close to that along the ridgelines designed using ArcMap (0.6°), and the elevation changes along most of the contour ridgelines showed a pattern of being higher in the middle and lower on both sides. (2) The positional offset between most of the measured and designed ridgelines was less than the width of a single ridge (1.3 m), and the median offset was one-third of the width of a single ridge. (3) The positional offset caused by the movement of ridging machinery could be larger than the offset resulting from the baseline setup, and verification points with larger positional offsets were often located at the edges of the plots as well as turns of the ridgelines. Therefore, during the designing ridgelines process, the turns should be made as smooth as possible. During ridging, reducing the speed at these turns to minimize errors and maintain the accuracy of the ridgeline was recommended. The findings of this study can provide a scientific basis to improve contour ridging design and effect prediction in slope farmland to control soil erosion and enhance agricultural sustainability.

show abstract

Section: Introductionmentioning

confidence: 99%