Strength and Structural Performance of Reinforced Concrete Beam with Artificial Plastic Fibre (APF)

Abstract

Behaviour of Reinforced Concrete (RC) in beam structure has captured attention of many researchers. Many past researchers investigated the issue of concrete strength in tensile zone. The present research investigates the effect of waste nylon cable ties fibre that act as an Artificial Plastic Fibres (APF) in normal concrete mix and RC beam element. The concrete strength of 30 MPa have been utilized in this research. The percentage of APF that has been mixed with the concrete paste are 1% and 3%. For strength performance, nine (9) cube specimens and nine (9) cylinder specimens were tested under compressive and splitting tensile test, respectively. In addition, six (6) RC beam specimens were prepared and tested under three points bending test in order to investigate its structural performance. Based on the results, 0%, 1% and 3% of APF in concrete mix produces tensile strength of 1.89 MPa, 3.37 MPa and 2.66 MPa respectively. While, from the compression tests, 50.9 MPa, 47.2 MPa and 24.5 MPa were generated from 0%, 1% and 3% of APF, respectively. From this observations, only 1% of APF was employed in concrete mix to produce RC beam for structural performance investigations. Based on three point bending test, RC beam that consisting 1% of APF produced maximum load about 35.98 kN with 1.8 mm deflection compared with control specimen that can only endured until 27.93 kN of maximum load with 2.37 mm deflection. Further observation reveals that cracking of RC beam consisting 1% of APF reduce and delay the crack formation. Overall, utilization of 1% APF in RC beam successfully improves its strength and structural performance.

Physical, mechanical, and durability properties of concrete containing different waste synthetic fibers for green environment – A critical review

“…Also, the same observation with Mokhatar et al [ 94 ] found WSF can significantly improve the tensile strength capacity of concrete. Hence, this study reported waste synthetic fiber has the capacity to replicate the existing steel fiber and lessens the quantity of waste synthetic products disposed on the land and enhance a clean environment for the upcoming generation.…”