Synthesis, characterization and evaluation of a quadripolymer with low molecular weight as a water based drilling fluid viscosity reducer at high temperature (245 °C)

Abstract

To construct an ultra‐high temperature stable drilling mud with a relatively low viscosity, a new viscosity‐reducing additive was synthesized and evaluated. This additive is a quadripolymer of acrylic acid (AA), 2‐acryl‐amido‐2‐methyl‐1‐propane sulfonic acid (AMPS), methyl acrylate (MA) and dimethyl diallyl ammonium chloride (DDAC) with low molecular weight synthesized by free radical polymerization, and its general molecular composition was confirmed by Fourier transform infrared spectroscopy. Thermal gravimetric analysis showed that the polymer has a very high temperature tolerance, i.e. it is stable up to 340 °C. Turbidity measurements with a UV−visible spectrophotometer showed that the polymer has a high salt tolerance in solution. It remained in solution at NaCl concentrations of up to 266 958 mg L−1 and at CaCl2 concentrations of up to 5000 mg L−1. The quadripolymer was found to inhibit hydration of the exchangeable ions in the clay particles and this was affirmed by a reduction in interlayer spacing. It also displayed high adsorption on calcium montmorillonite at different pH and even in the presence of NaCl, and caused the breakup of the particle network structure. This additive, when added to drilling mud prepared in both fresh and salt water, was found to reduce the mud viscosity and yield stress before and after aging for 16 h at 245 °C compared to base mud especially below 220 °C and 4.5 MPa. Importantly, this additive in mud was found to perform effectively at a relatively high pH and in a broad pH range of 7–11. © 2015 Society of Chemical Industry

Synthesis of a Low-Molecular-Weight Filtrate Reducer and Its Mechanism for Improving High Temperature Resistance of Water-Based Drilling Fluid Gel System

“…The Z-average molecular weight (M z ) of Driscal D Polymer is three orders of magnitude higher than that of LDMS. In the chemical category, low-molecular-weight polymers [ 28 ] are polymers with small relative molecular weights ranging from 1 × 10 3 to 6 × 10 3 . LDMS satisfies the relative molecular weight requirements of low-molecular-weight polymers, indicating that the low-molecular-weight filtrate reducer LDMS was synthesized successfully.…”

Study of a High-Temperature and High-Density Water-Based Drilling Fluid System Based on Non-sulfonated Plant Polymers

“…The VR-H viscosity reducer also formed a polymer complex with polyacrylamide in the water-based drilling fluid system, which can reduce the adsorption bridging effect of polyacrylamide on clay particles and the interaction between hydrolyzed polyacrylamide molecules, so that the structural viscosity and liquid viscosity of the drilling fluid are decreased. Therefore, VR-H can keep the solid particles in drilling fluid well dispersed, prevent the passivation and aggregation of clay at high temperature, reduce the friction between solid particles, and thus reduce the viscosity of the drilling fluid [ 26 ].…”

Study of Drilling Fluid System of Resisting the High Temperature of 220 Degrees

“…Drilling fluid performance of the density 1.06g/cm 3 The experimental results show that the anti-soluble salt (NaCl and CaCl 2 ) pollution capability proves to be perfect in the organo-silica system. The organo-silica high-temperature-resistant water-based drilling fluid system can resist 6%NaCl, 0.5%CaCl 2 and 15% cuttings under the high temperature of 220℃ for 16h.…”