Testing and Analysis of Fasteners

Abstract

By considering the tightening process, the experimental testing will be conducted to explore the mechanism of bolt selfloosening under biaxial loading. The most common mode of failure is overloading: Operating forces of the application produce loads that exceed the clamp load, causing the joint to loosen over time or fail catastrophically. Over torque might cause failure by damaging the threads and deforming the fastener, though this can happen over a very long time. Also, the bolts may fail under fatigue. The components used in the system are bolts, pneumatic cylinder and flow control valve. The pneumatic cylinder is actuated with the help of compressor. The flow of air in the cylinder will be controlled with the help of pneumatic cylinder which will be acted on the bolts in two directions that is from downward & upward direction. This means the load will be tensile and shearing load. The bolts are attached to the plates. Because of actuation of the pneumatic cylinder the bolts will become loose. These bolts will be tested by using biaxial loading. The result & conclusion was drawn after the experimental testing. Keywords: Bi-axial Loading, Fasteners, Bolt Loosening, Residual Torque, Fastener Overloading