The four-channel WDM system using Semiconductor Optical Amplifier

Ivaniga, Tomáš; Ovseník, Ľuboš; Turán, Ján

doi:10.1109/radioelek.2016.7477350

Cited by 15 publications

(11 citation statements)

References 4 publications

Supporting

Mentioning

Contrasting

Unclassified

Order By: Relevance

“…Empat panjang gelombang yang berbeda yang diintrepresentasikan dengan warna yang berbeda, lalu digabung oleh perangkat combining optical signals atau dikenal sebagai multiplexer sehingga dalam satu serat akan dikirimkan beberapa panjang gelombang sekaligus dalam waktu yang bersamaan. Pada blok separating optical signals atau blok demultiplexer dipisahkan kembali panjang gelombang yang diinginkan, lalu selanjutnya akan dideteksi oleh photodetector [4].…”

Section: Pendahuluanunclassified

Simulasi Radio over Fiber pada Frekuensi 2.4 GHz Berbasis Wavelength Division Multiplexing Menggunakan Fiber Bragg Gratings

Perdana

Firdausi

2021

InComTech

View full text Add to dashboard Cite

Teknologi Radio over Fiber (RoF) dapat diaplikasikan guna mendukung layanan broadband, dimana RoF merupakan sebuah teknologi untuk menggabungkan antara transmisi radio dan fiber optik. Peningkatan kapasitas jaringan RoF dapat menggunakan teknik Wavelength Division Multiplexing (WDM) yaitu teknologi yang menggabungkan beberapa panjang gelombang untuk dilewatkan pada suatu serat optik. WDM juga bertujuan agar memperoleh sistem dengan bandwidth dan kapasistas yang besar serta meningkatkan kapasitas jaringan RoF . Penambahan filter Fiber Bragg Gratings (FBG) dilakukan untuk meningkatkan performansi jaringan. Pada perancangan ini, FBG diletakkan pada sisi receiver. Simulasi perancangan teknologi RoF ini menggunakan Software Optisytem yang bekerja pada unlicenced band frekuensi yaitu frekuensi 2,4 Ghz. Kinerja sistem dievaluasi dari segi Q-factor, BER dan Power link budget menggunakan software optisystem versi 15.

show abstract

Section: Pendahuluanunclassified

Simulasi Radio over Fiber pada Frekuensi 2.4 GHz Berbasis Wavelength Division Multiplexing Menggunakan Fiber Bragg Gratings

Perdana

Firdausi

2021

InComTech

View full text Add to dashboard Cite

show abstract

“…Using logical NOT component, the logical state of data is inverted in one of the two arms. Signals in both arms are then driven through NRZ modulator driver and modulated using optical dual-drive Mach-Zehnder modulator (DDMZM) [10]. Theory wise, duobinary modulation provide higher spectral efficiency than NRZ based modulation as well as higher tolerance to chromatic dispersion.…”

Section: The Simulation Model Of 10g-pon Ftth Systemmentioning

confidence: 99%

Simulation of Downlink of 10G-PON FTTH in the city of Košice

Huszaník

Turán

Ovseník

2018

Carpathian Journal of Electronic and Computer Engineering

View full text Add to dashboard Cite

Optical fiber has the great advantages of capacity and reliability. That is why network providers started to deploy FTTx (Fiber-To-The-x) optical access using various PON (Passive Optical Network) architectures. The leading technology right now is Gigabit PON (GPON). However, with increasing amount of multimedia we need to further develop existing technologies to go on with these high demands. Fiber-To-The-Home (FTTH) using 10G-PON technology for broadband access application is effective solution for high speed networks with high capacity. In this paper, we look at the passive optical network in the city of Košice and based on the real network we created simulation model of downlink of 10G-PON based FTTH with triple-play service.

show abstract

“…[20]. Pump current for SOA has been selected on the basis of achieved results [21]. BER ranged from 1 ⋅ 10 −4 to 1 ⋅ 10 −12 .…”

Section: Design Of the Dwdm System For The Comparison Of Edfa And Soamentioning

confidence: 99%

“…BER ranged from 1 ⋅ 10 −4 to 1 ⋅ 10 −12 . From the results published in this article SOA amplifier was designed in order to reach the best error rate for particular wavelengths [21]. The EDFA parameter settings and the length of erbium doped fibre have been designed on the basis of [22].…”

Section: Design Of the Dwdm System For The Comparison Of Edfa And Soamentioning

confidence: 99%

Comparison of the Optical Amplifiers EDFA and SOA Based on the BER and Q-Factor in C-Band

Ivaniga

2017

Advances in Optical Technologies

View full text Add to dashboard Cite

Currently it is not possible to create a fully optical communication system without a software tool which simulates an optical communication line in real conditions prior to its construction. The aim of this article is to establish a comparison between the EDFA (erbium doped fibre amplifier) and SOA (semiconductor optical amplifier) optical amplifiers in the WDM (wavelength division multiplexing) system. The system contains a four-channel WDM with speed of 10 Gbps and optical fibre with length of 80 km. Simulations are conducted in the programme environment “OptSim.” The quality of the optical communication system is evaluated by the BER (bit error rate) and Q-factor for individual wavelengths, namely, of 1558 nm and 1562 nm, which are within the C-band.

show abstract

The four-channel WDM system using Semiconductor Optical Amplifier

Cited by 15 publications

References 4 publications

Simulasi Radio over Fiber pada Frekuensi 2.4 GHz Berbasis Wavelength Division Multiplexing Menggunakan Fiber Bragg Gratings

Simulasi Radio over Fiber pada Frekuensi 2.4 GHz Berbasis Wavelength Division Multiplexing Menggunakan Fiber Bragg Gratings

Simulation of Downlink of 10G-PON FTTH in the city of Košice

Comparison of the Optical Amplifiers EDFA and SOA Based on the BER and Q-Factor in C-Band

Contact Info

Product

Resources

About