The MBRD Dipoles for the Luminosity Upgrade at the LHC: From Prototype Tests to the Series Production

Farinon, S.; Angius, Silvano; Barutti, A.; Bersani, A.; Caiffi, B.; Fabbricatore, P.; Fiscarelli, Lucio; Foussat, A.; Guinchard, Michael; Levi, Filippo; Mangiarotti, Franco; Ninet, Gaelle; Novelli, Daniel; Pampaloni, Alessandra; Todesco, E.; Valle, Nico; Verardo, Alessio; Willering, Gerard

doi:10.1109/tasc.2023.3238988

Cited by 5 publications

(1 citation statement)

References 9 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Magnet manufacturing has been assigned to ASG, followed-up by INFN-Genova, where a 3-m-long magnet with similar parameters for SIS-300 was manufactured in 2015 [22]. The main challenge of D2 is the magnetic cross-talk between the two apertures, requiring a 1 mm left-right asymmetry in the coil geometry to compensate for this effect [3,8,23].…”

Section: The Recombination Dipole D2mentioning

confidence: 99%

Status and Challenges of the Interaction Region Magnets for HL-LHC

Todesco

Bermúdez

Foussat

et al. 2023

IEEE Trans. Appl. Supercond.

View full text Add to dashboard Cite

About one hundred magnets of six different types shall be installed in the High Luminosity LHC (HL-LHC) in the years 2026-2028 at CERN. The magnets design, construction and test are based on CERN collaborations with institutes and industrial partners in USA, Spain, Italy, Japan and China. Three types of correctors are based on Nb-Ti technology and feature conductor peak fields in the 2 to 4 T range: for all of them the protoype phase has been successfully completed. The production is well advanced for the superferric correctors, and is starting for the canted cosine theta correctors and for the nested correctors. The separation and recombination Nb-Ti dipoles D1 and D2, with a 4.5-6 T bore field range, are both in the prototype phase after the completion of the short model program. The most challenging magnet, the Nb3Sn quadrupole with conductor peak field above 11 T, is in the prototype phase at CERN and halfway through the production phase in the USA. In this paper we will give, for each type of magnet, an overview of the main achievements obtained so far and we will outline the technical points still needing validation from the prototype program.

show abstract

Section: The Recombination Dipole D2mentioning

confidence: 99%