Tunable thermoresponsive TiO₂/SiO₂ Bragg stacks based on sol–gel fabrication methods

Abstract

Thermoresponsive TiO 2 /SiO 2 one-dimensional photonic crystals (Bragg stacks) fabricated via sol-gel processing methods represent a promising class of environmentally responsive nanostructures featuring optically encoded temperature and humidity detection. The thermo-optic response of the layer materials is amplified by their inherent porosity owing to adsorption/desorption of ambient humidity into the mesoporous multilayer structure. Based on a comprehensive analysis of the impact of layer thickness, refractive index and thermo-optic coefficient on the stop band position, and width of various Bragg stack architectures, design criteria for thermoresponsive Bragg stacks operating in the visible range of the optical spectrum are put forward. A large and well-defined thermo-optic signature is expected for material combinations featuring individually high thermo-optic coefficients with the same sign or allowing for large changes in the effective refractive indices due to water adsorption in the porous layers reinforcing the thermo-optic response, as observed in the TiO 2 /SiO 2 couple. Important practical aspects of the performance of thermoresponsive Bragg stacks are addressed, including the hysteresis properties of TiO 2 /SiO 2 Bragg stacks during multiple heating/cooling cycles, as well as response and recovery times (;2-4 s) of the multilayer system during external changes in ambient humidity.

Multiperiodic Photonic Crystals for Ultrasensitive Temperature Monitoring and Polarization Switching

“…We calculate the transmittivity spectra of the electromagnetic waves of near IR range propagating through the 1D threeperiodic PCs using the standard transfer matrix method, see for details, [36]. The material parameters (refractive indices, thermo-optic coefficients, and thermal expansion coefficients) for all the PC constituents were taken in [28][29][30][31]33].…”

A surface plasmon resonance temperature sensor using TiO2 nanoparticles on hetero-core fiber optic structure with Au thin film

“…The calculated resonant wavelength shifts were largely smaller than the experimentally obtained shifts, which was because the temperature dependence of the dielectric constant for TiO 2 NPs is known to be higher than that of bulk TiO 2 . 36,37) To evaluate the temperature dependency in terms of different TiO 2 thicknesses, the SPR calculation was implemented using the dielectric function of bulk TiO 2 , which was used in a previous study of TiO 2 formed by the RF sputtering method. 25) As mentioned above, the obtained broad SPR spectra allow for light intensity mode operation using a simple combination of a single wavelength light source, such as a light-emitting diode and an optical power detector to measure the temperature change.…”

When nothing is constant but change: Adaptive and sensorial materials and their impact on product design

“…Also dedicated to facilitate low-cost environmental monitoring, and specifically evaluated in thermooptical sensing, are devices studied by Pavlichenko et al (2012) which integrate photonic crystal-based tuneable light-emitting devices with Bragg stacks exhibiting refractive index changes when experiencing measurand shifts.…”