Using the Portapres^® for the measurement of toe arterial blood pressure during movement: is it valid and reliable?

Abstract

The aim of the study was to assess the validity and reliability of using the Portapres® to measure toe blood pressure during rest and exercise. Construct validity, concurrent validity, and interday reliability were assessed by measuring toe (Portapres®)) and brachial blood pressure in 16 nondisabled participants on consecutive days. Construct validity was assessed by pedaling on a cycle ergometer (6 revolutions per minute) and comparing the measured toe blood pressure to an estimated value based on orthostatic factors. Concurrent validity was assessed by comparing toe and brachial blood pressure during supine rest and following 10 min of cycling exercise. Interday reliability was assessed by recording toe and brachial blood pressure during supine rest on a second day. Construct validity analysis shows that the toe blood pressure signal was moderately correlated with the changes in heart–toe distance and that changes in toe blood pressure during slow cycling were similar to the estimated value. Resting toe and brachial mean arterial blood pressure showed concurrent validity with only a fixed bias explained by the change in orthostatic pressure and the toe–brachial index. Furthermore, cycling exercise was associated with an increase in brachial and a decrease in toe mean blood pressure. The interday reliability analysis showed no proportional or fixed bias for mean arterial blood pressure. Our study showed the feasibility of using the Portapres® to measure toe blood pressure during movement and can be used to study the effect of movement‐related forces during cycling on toe blood pressure.

Causal analyses to study autonomic regulation during acute head‐out water immersion, head‐down tilt and supine position

“…If such correction was not possible, a cubic spline interpolation was used to correct for isolated artefacts and ectopic beats. Maximal blood pressure values after the R‐wave peaks were classified as SBP (Goreham, Kimmerly, & Ladouceur, 2017). The RE signal was derived from the ECG signal by analysing the distortion of the R‐wave peak attribugtable to induced respiratory thoracic motion (Moody, Mark, Zoccola, & Mantero, 1985).…”

CVRanalysis: a free software for analyzing cardiac, vascular and respiratory interactions

“…First, R peaks are detected from the ECG signal using a laboratory developed algorithm (Pichot et al, 2016). Then maximum and minimum BP values between RR are classified as systolic and diastolic BP, respectively (Goreham et al, 2017). The MBP value is also calculated as the mean of the blood pressure curve taken between the successive diastoles.…”