Vibrational and X-ray diffraction spectra of SnS film deposited by chemical bath deposition method

SnS thin films deposited by chemical bath deposition, dip coating and SILAR techniques

“…and 312 cm −1 , are in good agreement with the results of S. Aksay et al [36]. The peaks associated to other phase of tin sulphides are not visible in case of sample S2 that strongly states that high temperature CBD deposition gives perfect single SnS phase.…”

Preparation and the growth mechanism of zinc blende structure tin sulfide films by successive ionic layer adsorption and reaction

“…It can be seen that after the annealing, the amount of chemisorbed water decreased. Peaks at 581 cm À 1 , 714 cm À 1 and 890 cm À 1 are due to Sn-O, Sn-O 2 and Sn(OH) 2 [17]. From the figure, we can see that when NH 4 Cl or NaCl is added to cation solution, the amount of Sn-O or Sn(OH) 2 is increased in the prepared films.…”

GO nanosheets decorated with SnS nanoparticles: excellent photocatalytic performance under visible-light irradiation

“…However, since almost all factors are strongly coupled, it is not possible to determine the effect of each of parameters on the PL results. 53,54 The FT-IR spectra of the synthesized nanostructures were recorded in the transmission wavenumber range of 500-4000 cm À1 and are shown in Fig. 9.…”

“…13,22 On the other hand, with the increase in the concentration of graphene oxide, it can be seen that the absorption peak at 769 cm À1 becomes wider and almost disappears, which according to the reports presented can indicate the increase of oxygen in the nanostructures due to the presence of graphene oxide. 20,53 On the other hand, one of the most important factors affecting photocatalytic efficiency is the porosity of nanostructures. The effect of graphene oxide on the textural characteristics of SnS/rGO nanocomposite was investigated by BET.…”

“…However, since almost all factors are strongly coupled, it is not possible to determine the effect of each of parameters on the PL results. 53,54…”