Visible-light-driven super-active Sn and GO single- and Sn/Cu Co-doped nanophotocatalysts for phenol degradation: Thin-film printability, thermal stability, and cytotoxicity assay

Optimization of Photoelectrochemical Response on TiO2 Nanotube Arrays Treated by H3PO4 and Mechanism Analysis of the Slowing Down Effect during Preparation

“…All samples were dipped into acetone and cleaned with an ultrasonic washer for 5 min after preparation. The samples prepared in 0 or 5 wt % H 3 PO 4 -containing electrolyte at 50 V were annealed in a muffle furnace (heated at 5 °C/min from 20 to 450 °C), held for an hour at 450 °C, and then cooled to room temperature naturally. − …”

Use of Zero-Valent Iron Nanoparticles (nZVIs) from Environmentally Friendly Synthesis for the Removal of Dyes from Water—A Review

“…This solution evolves into a network, or gel, of the aforesaid monomer. Once the gel is formed, the excess of solvent must be removed, and finally, a drying or calcination step is required [55][56][57]. The efficiency of the process is usually very high, above 70%, and with moderate energy consumption, most of which is consumed in the drying/calcination process.…”

A Comprehensive Computational Fluid Dynamics Modeling of Lithium Sulphate Electrodialysis

“…The behavior of ED can be investigated by either experimental works or mathematical models. In contrast with experimental studies, 17,18 mathematical models aim to investigate the ED's behavior by involving the formulation of equations derived from fundamental principles of ED, i.e., mass conservation, ion and water transport mechanisms, and the electroneutrality condition. Depending on the purpose of the mathematical model, whether to offer a simplistic representation with minimal input or provide predictions with high fidelity, the resulting formulation could involve different forms of equations, which can be solved through either analytical or numerical methods.…”