The design of the Lunar Exploration Neutron Detector (LEND) experiment is presented, which was optimized to address several of the primary measurement requirements of NASA's Lunar Reconnaissance Orbiter (LRO): high spatial resolution hydrogen mapping of the Moon's upper-most surface, identification of putative deposits of appreciable nearsurface water ice in the Moon's polar cold traps, and characterization of the human-relevant space radiation environment in lunar orbit. A comprehensive program of LEND instrument physical calibrations is discussed and the baseline scenario of LEND observations from the primary LRO lunar orbit is presented. LEND data products will be useful for determining the next stages of the emerging global lunar exploration program, and they will facilitate the study of the physics of hydrogen implantation and diffusion in the regolith, test the presence of water ice deposits in lunar cold polar traps, and investigate the role of neutrons within the radiation environment of the shallow lunar surface.

No abstract

Data gathered with the Dynamic Albedo of Neutron (DAN) instrument onboard rover Curiosity were analyzed for variations in subsurface neutron flux and tested for possible correlation with local geological context. A special DAN observation campaign was executed, in which 18 adjacent DAN active measurements were acquired every 0.75-1.0 m to search for the variations of subsurface hydrogen content along a 15 m traverse across geologic contacts between the Sheepbed and Gillespie Lake members of the Yellowknife Bay formation. It was found that several subunits in Sheepbed and Gillespie Lake could be characterized with different depth distributions of water-equivalent hydrogen (WEH) and different chlorine-equivalent abundance responsible for the distribution of neutron absorption elements. The variations of the average WEH at the top 60 cm of the subsurface are estimated at up to 2-3%. Chlorine-equivalent neutron absorption abundances ranged within 0.8-1.5%. The largest difference in WEH and chlorine-equivalent neutron absorption distribution is found between Sheepbed and Gillespie Lake.

[1] The Dynamic Albedo of Neutrons (DAN) instrument on board Mars Science Laboratory has been operating successfully since the landing and has been making measurements regularly along Curiosity's traverse at the surface. DAN measures thermal (E < 0.4 eV) and epithermal neutrons (0.4 eV < E <~1 keV) while operating in two different modes: active and passive. The active mode uses a pulsed neutron generator (PNG) to study the geological characteristics of the subsurface. In the passive mode, DAN measures the background neutron environment. This paper presents results of measurements in the passive mode from landing through to sol 100 and provides an interpretation of the data based on extensive Monte Carlo simulations. The main observations are summarized as follows: (1) the thermal neutron counts vary strongly along the rover traverse while the epithermal counts do not show much variation; (2) the neutrons from the Multi-Mission Radioisotope Thermoelectric Generator (MMRTG) are a larger contributor to the DAN passive data than the Galactic Cosmic Ray (GCR)-induced neutrons; (3) for the MMRTG neutrons, both the thermal and the epithermal counts increase as a function of the subsurface water content; (4) on the other hand, for the GCR-induced neutrons, the thermal counts increase but the epithermal counts decrease as a function of the subsurface water content; and (5) relative contributions by the MMRTG and GCR to the DAN thermal neutron counts at the Rocknest site, where the rover was stationed from sol 59 to sol 100, are estimated to be~60% and~40%, respectively.

The Dynamic Albedo of Neutron (DAN) instrument on board the Mars Science Laboratory Curiosity rover acquired a series of measurements as part of an observational campaign of the Kimberley area in Gale crater. These observations were planned to assess the variability of bulk hydrogen and neutron‐absorbing elements, characterized as chlorine‐equivalent concentration, in the geologic members of the Kimberley formation and in surface materials exposed throughout the area. During the traverse of the Kimberley area, Curiosity drove primarily over the “Smooth Hummocky” unit, a unit composed primarily of sand and loose rocks, with occasional stops at bedrock of the Kimberley formation. During the Kimberley campaign, DAN detected ranges of water equivalent hydrogen (WEH) and chlorine‐equivalent concentrations of 1.5–2.5 wt % and 0.6–2 wt %, respectively. Results show that as the traverse progressed, DAN observed an overall decrease in both WEH and chlorine‐equivalent concentration measured over the sand and loose rocks of the Smooth Hummocky unit. DAN measurements of WEH and chlorine‐equivalent concentrations in the well‐exposed sedimentary bedrock of the Kimberley formation show fluctuations with stratigraphic position. The Kimberley campaign also provided an opportunity to compare measurements from DAN with those from the Sample Analysis at Mars (SAM) and the Alpha‐Particle X‐ray Spectrometer (APXS) instruments. DAN measurements obtained near the Windjana drill location show a WEH concentration of ~1.5 wt %, consistent with the concentration of low‐temperature absorbed water measured by SAM for the Windjana drill sample. A comparison between DAN chlorine‐equivalent concentrations measured throughout the Kimberley area and APXS observations of corresponding local surface targets and drill fines shows general agreement between the two instruments.