Regolith particles on the asteroid Itokawa were recovered by the Hayabusa mission. Their three-dimensional (3D) structure and other properties, revealed by x-ray microtomography, provide information on regolith formation. Modal abundances of minerals, bulk density (3.4 grams per cubic centimeter), and the 3D textures indicate that the particles represent a mixture of equilibrated and less-equilibrated LL chondrite materials. Evidence for melting was not seen on any of the particles. Some particles have rounded edges. Overall, the particles' size and shape are different from those seen in particles from the lunar regolith. These features suggest that meteoroid impacts on the asteroid surface primarily form much of the regolith particle, and that seismic-induced grain motion in the smooth terrain abrades them over time.

Samples of the carbonaceous asteroid Ryugu were brought to Earth by the Hayabusa2 spacecraft. We analyzed seventeen Ryugu samples measuring 1-8 mm. CO 2 -bearing water inclusions are present within a pyrrhotite crystal, indicating that Ryugu’s parent asteroid formed in the outer Solar System. The samples contain low abundances of materials that formed at high temperatures, such as chondrules and Ca, Al-rich inclusions. The samples are rich in phyllosilicates and carbonates, which formed by aqueous alteration reactions at low temperature, high pH, and water/rock ratios < 1 (by mass). Less altered fragments contain olivine, pyroxene, amorphous silicates, calcite, and phosphide. Numerical simulations, based on the mineralogical and physical properties of the samples, indicate Ryugu’s parent body formed ~ 2 million years after the beginning of Solar System formation.

A compositional variety of planetary cores provides insight into their core/mantle evolution and chemistry in the early solar system. To infer core composition from geophysical data, a precise knowledge of elastic properties of core‐forming materials is of prime importance. Here, we measure the sound velocity and density of liquid Fe‐Ni‐S (17 and 30 at% S) and Fe‐Ni‐Si (29 and 38 at% Si) at high pressures and report the effects of pressure and composition on these properties. Our data show that the addition of sulfur to iron substantially reduces the sound velocity of the alloy and the bulk modulus in the conditions of this study, while adding silicon to iron increases its sound velocity but has almost no effect on the bulk modulus. Based on the obtained elastic properties combined with geodesy data, S or Si content in the core is estimated to 4.6 wt% S or 10.5 wt% Si for Mercury, 9.8 wt% S or 18.3 wt% Si for the Moon, and 32.4 wt% S or 30.3 wt% Si for Mars. In these core compositions, differences in sound velocity profiles between an Fe‐Ni‐S and Fe‐Ni‐Si core in Mercury are small, whereas for Mars and the Moon, the differences are substantially larger and could be detected by upcoming seismic sounding missions to those bodies.

X-ray microtomography was used to observe hydrogen micropores and their growth behavior at high temperatures in several aluminum alloys. High-density micropores were observed in highpurity Al-Mg alloys, but their density and volume fraction were much lower in pure aluminum. Our results have revealed that the growth behavior of micropores is dominated by Ostwald ripening. About 53 % of hydrogen is trapped in micropores in Al-Mg alloy with low hydrogen content, making micropores the predominant hydrogen trap site. Although total hydrogen content is similar to that in the alloy, the ratio of hydrogen trapped in micropores is below 7 % in pure aluminum. This difference is attributable to the lack of hydrogen precipitation sites in pure aluminium.Although the overall amounts of hydrogen at dislocations and grain boundaries are small in all the materials, the occupancies for these trap sites were concluded to be very high.