The correlation between atomic structure and the electrical properties of thermally grown SiO2/4H-SiC(0001) interfaces was investigated by synchrotron x-ray photoelectron spectroscopy together with electrical measurements of SiC-MOS capacitors. We found that the oxide interface was dominated by Si-O bonds and that there existed no distinct C-rich layer beneath the SiC substrate despite literature. In contrast, intermediate oxide states in Si core-level spectra attributable to atomic scale roughness and imperfection just at the oxide interface increased as thermal oxidation progressed. Electrical characterization of corresponding SiC-MOS capacitors also indicated an accumulation of both negative fixed charges and interface defects, which correlates well with the structural change in the oxide interface and provides insight into the electrical degradation of thermally grown SiC-MOS devices.

The oxidation of Cu{100} with a hyperthermal O2 molecular beam (HOMB) was investigated using x-ray photoemission spectroscopy in conjunction with a synchrotron light source. The efficiency of oxidation with HOMB is higher than that with ambient thermal O2. Further oxidation under oxygen coverage (Θ)⩾0.5 ML occurs rather inefficiently even for the 2.3-eV-HOMB irradiation. We found that such slow oxidation of Cu corresponding to the initial stage of the Cu2O formation can be interpreted in terms of a collision-induced-absorption mechanism. The kinetics of the dissociative adsorption under Θ⩽0.5 ML is well described using the first-order kinetics in a simple Langmuir-type adsorption model.

Initial oxidation of gallium nitride (GaN) (0001) epilayers and subsequent growth of thermal oxides in dry oxygen ambient were investigated by means of x-ray photoelectron spectroscopy, spectroscopic ellipsometry, atomic force microscopy, and x-ray diffraction measurements. It was found that initial oxide formation tends to saturate at temperatures below 800 °C, whereas the selective growth of small oxide grains proceeds at dislocations in the epilayers, followed by noticeable grain growth, leading to a rough surface morphology at higher oxidation temperatures. This indicates that oxide growth and its morphology are crucially dependent on the defect density in the GaN epilayers. Structural characterizations also reveal that polycrystalline α- and β-phase Ga2O3 grains in an epitaxial relation with the GaN substrate are formed from the initial stage of the oxide growth. We propose a comprehensive model for GaN oxidation mediated by nitrogen removal and mass transport and discuss the model on the basis of experimental findings.

A simple and feasible method for fabricating high-quality and highly reliable GaN-based metal-oxide-semiconductor (MOS) devices was developed. The direct chemical vapor deposition of SiO 2 films on GaN substrates forming Ga-oxide interlayers was carried out to fabricate SiO 2 / GaO x /GaN stacked structures. Although well-behaved hysteresis-free GaN-MOS capacitors with extremely low interface state densities below 10 10 cm %2 eV %1 were obtained by postdeposition annealing, Ga diffusion into overlying SiO 2 layers severely degraded the dielectric breakdown characteristics. However, this problem was found to be solved by rapid thermal processing, leading to the superior performance of the GaN-MOS devices in terms of interface quality, insulating property, and gate dielectric reliability.

The superior physical and electrical properties of aluminum oxynitride (AlON) gate dielectrics on AlGaN/GaN substrates in terms of thermal stability, reliability, and interface quality were demonstrated by direct AlON deposition and subsequent annealing. Nitrogen incorporation into alumina was proven to be beneficial both for suppressing intermixing at the insulator/AlGaN interface and reducing the number of electrical defects in Al2O3 films. Consequently, we achieved high-quality AlON/AlGaN/GaN metal–oxide–semiconductor capacitors with improved stability against charge injection and a reduced interface state density as low as 1.2 × 1011 cm−2 eV−1. The impact of nitrogen incorporation into the insulator will be discussed on the basis of experimental findings.