Background. The pilot phase IIb VIKING study suggested that dolutegravir (DTG), a human immunodeficiency virus (HIV) integrase inhibitor (INI), would be efficacious in INI-resistant patients at the 50 mg twice daily (BID) dose.Methods. VIKING-3 is a single-arm, open-label phase III study in which therapy-experienced adults with INI-resistant virus received DTG 50 mg BID while continuing their failing regimen (without raltegravir or elvitegravir) through day 7, after which the regimen was optimized with ≥1 fully active drug and DTG continued. The primary efficacy endpoints were the mean change from baseline in plasma HIV-1 RNA at day 8 and the proportion of subjects with HIV-1 RNA <50 c/mL at week 24.Results. Mean change in HIV-1 RNA at day 8 was −1.43 log10 c/mL, and 69% of subjects achieved <50 c/mL at week 24. Multivariate analyses demonstrated a strong association between baseline DTG susceptibility and response. Response was most reduced in subjects with Q148 + ≥2 resistance-associated mutations. DTG 50 mg BID had a low (3%) discontinuation rate due to adverse events, similar to INI-naive subjects receiving DTG 50 mg once daily.Conclusions. DTG 50 mg BID–based therapy was effective in this highly treatment-experienced population with INI-resistant virus.Clinical Trials Registration.  (NCT01328041) and (112574).

The vaccine was generally well tolerated and induced cell-mediated immune responses against human immunodeficiency virus type 1 peptides in most healthy adults. Despite these findings, vaccination in a proof-of-concept trial with use of this vaccine was discontinued because of lack of efficacy.

a Zirconium trisulphide (ZrS 3 ), a member of the layered transition metal trichalcogenides (TMTCs) family, has been studied by angle-resolved photoluminescence spectroscopy (ARPLS). The synthesized ZrS 3 layers possess a pseudo one-dimensional nature where each layer consists of ZrS 3 chains extending along the b-lattice direction. Our results show that the optical properties of few-layered ZrS 3 are highly anisotropic as evidenced by large PL intensity variation with the polarization direction. Light is efficiently absorbed when the E-field is polarized along the chain (b-axis), but the field is greatly attenuated and absorption is reduced when it is polarized vertical to the 1D-like chains as the wavelength of the exciting light is much longer than the width of each 1D chain. The observed PL variation with polarization is similar to that of conventional 1D materials, i.e., nanowires, and nanotubes, except for the fact that here the 1D chains interact with each other giving rise to a unique linear dichroism response that falls between the 2D ( planar) and 1D (chain) limit. These results not only mark the very first demonstration of PL polarization anisotropy in 2D systems, but also provide novel insight into how the interaction between adjacent 1D-like chains and the 2D nature of each layer influences the overall optical anisotropy of pseudo-1D materials. Results are anticipated to have an impact on optical technologies such as polarized detectors, near-field imaging, communication systems, and bio-applications relying on the generation and detection of polarized light.

Transition metal trichalcogenides form a class of layered materials with strong in-plane anisotropy. For example, titanium trisulfide (TiS3) whiskers are made out of weakly interacting TiS3 layers, where each layer is made of weakly interacting quasi-one-dimensional chains extending along the b axis. Here we establish the unusual vibrational properties of TiS3 both experimentally and theoretically. Unlike other two-dimensional systems, the Raman active peaks of TiS3 have only out-of-plane vibrational modes, and interestingly some of these vibrations involve unique rigid-chain vibrations and S–S molecular oscillations. High-pressure Raman studies further reveal that the AgS–S S-S molecular mode has an unconventional negative pressure dependence, whereas other peaks stiffen as anticipated. Various vibrational modes are doubly degenerate at ambient pressure, but the degeneracy is lifted at high pressures. These results establish the unusual vibrational properties of TiS3 with strong in-plane anisotropy, and may have relevance to understanding of vibrational properties in other anisotropic two-dimensional material systems.

Layered transition metal trichalcogenides (TMTCs) are a new class of anisotropic two-dimensional materials that exhibit quasi-1D behavior. This property stems from their unique highly anisotropic crystal structure where vastly different material properties can be attained from different crystal directions. Here, we employ density functional theory predictions, atomic force microscopy, and angle-resolved Raman spectroscopy to investigate their fundamental vibrational properties which differ significantly from other 2D systems and to establish a method in identifying anisotropy direction of different types of TMTCs. We find that the intensity of certain Raman peaks of TiS, ZrS, and HfS have strong polarization dependence in such a way that intensity is at its maximum when the polarization direction is parallel to the anisotropic b-axis. This allows us to readily identify the Raman peaks that are representative of the vibrations along the b-axis direction. Interestingly, similar angle resolved studies on the novel TiNbS TMTC alloy reveal that determination of anisotropy/crystalline direction is rather difficult possibly due to loss of anisotropy by randomization distribution of quasi-1D MX chains by the presence of defects which are commonly found in 2D alloys and also due to the complex Raman tensor of TMTC alloys. Overall, the experimental and theoretical results establish non-destructive methods used to identify the direction of anisotropy in TMTCs and reveal their vibrational characteristics which are necessary to gain insight into potential applications that utilize direction dependent thermal response, optical polarization, and linear dichroism.