The use of a complex short-period (Bragg) grating which combines matched periodic modulations of refractive index and loss/gain allows asymmetrical mode coupling within a contra-directional waveguide coupler. Such a complex Bragg grating exhibits a different behavior (e.g. in terms of the reflection and transmission spectra) when probed from opposite ends. More specifically, the grating has a single reflection peak when used from one end, but it is transparent (zero reflection) when used from the opposite end. In this paper, we conduct a systematic analytical and numerical analysis of this new class of Bragg gratings. The spectral performance of these, so-called nonreciprocal gratings, is first investigated in detail and the influence of device parameters on the transmission spectra of these devices is also analyzed. Our studies reveal that in addition to the nonreciprocal behavior, a nonreciprocal Bragg grating exhibits a strong amplification at the resonance wavelength (even with zero net-gain level in the waveguide) while simultaneously providing higher wavelength selectivity than the equivalent index Bragg grating. However, it is also shown that in order to achieve non-reciprocity in the device, a very careful adjustment of the parameters corresponding to the index and gain/loss gratings is required.

The design and characterization of a slow-wave series push-pull traveling wave silicon photonic modulator is presented. At 2 V and 4 V reverse bias, the measured -3 dB electro-optic bandwidth of the modulator with an active length of 4 mm are 38 GHz and 41 GHz, respectively. Open eye diagrams are observed up to bitrates of 60 Gbps without any form of signal processing, and up to 70 Gbps with passive signal processing to compensate for the test equipment. With the use of multi-level amplitude modulation formats and digital-signal-processing, the modulator is shown to operate below a hard-decision forward error-correction threshold of 3.8×10^-3 at bitrates up to 112 Gbps over 2 km of single mode optical fiber using PAM-4, and over 5 km of optical fiber with PAM-8. Energy consumed solely by the modulator is also estimated for different modulation cases.

No abstract

We propose and experimentally demonstrate an all-optical (all-fiber) temporal differentiator based on a simple pi-phase-shifted fiber Bragg grating operated in reflection. The proposed device can calculate the first time derivative of the complex field of an arbitrary narrowband optical waveform with a very high accuracy and efficiency. Specifically, the experimental fiber grating differentiator reported here offers an operation bandwidth of approximately 12 GHz. We demonstrate the high performance of this device by processing gigahertz-bandwidth phase and intensity optical temporal variations.

We report the enhanced photovoltaic properties in polycrystalline BiFeO3 (BFO) thin films with graphene as top electrodes. The short circuit current density (Jsc) and open circuit voltage of the heterojunction are measured to be 25 μA/cm2 and 0.44 V, respectively, much higher than the reported values for polycrystalline BFO with indium tin oxide (ITO) as top electrodes. Influence of HNO3 treatment on the photovoltaic properties is studied, and a significant photocurrent density improvement from 25 μA/cm2 to 2.8 mA/cm2 is observed. A metal-intrinsic semiconductor-metal model is proposed to explain the graphene induced enhancement comparing with traditional ITO.