No abstract

Parabolic trough concentrated solar power plants (PTCSP) are particularly promising renewable sources of energy, whose easy integration with Thermal Energy Storage (TES) systems allows to mitigate the intermittency of electricity generation. Currently, molten nitrates, with a two tanks arrangement, are mainly used for sensible heat accumulation. In order to reduce costs and make the CSP storage systems more manageable, single tank configurations have been proposed, where the cold and hot fluids are stored in the same container, and separated because of their density difference. The aim of the present work is to study the storage performances presented by two novel ternary and quaternary mixtures, proposed within the European project IN-POWER. An experimental campaign was preliminarily performed to investigate the fluids thermo-physical properties, and the obtained values were utilized as input data to model the discharge phase in a thermocline tank. The simulation results were compared with the ones acquired considering two commercial materials, namely, Solar Salt and Hitec XL®. Overall, considering same temperature ranges, higher discharging times are obtained for the quaternary and ternary mixtures, with the ternary presenting a smaller thermocline thickness than the solar salt while this parameter is the same considering the quaternary and Hitec XL®.

Molten salts eutectics are promising candidates as phase change materials (PCMs) for thermal storage applications, especially considering the possibility to store and release heat at high temperatures. Although many compounds have been proposed for this purpose in the scientific literature, very few data are available regarding actual applications. In particular, there is a lack of information concerning thermal storage at temperatures around 600 °C, necessary for the coupling with a highly efficient Rankine cycle powered by concentrated solar power (CSP) plants. In this contest, the present work deals with a thermophysical behavior investigation of a storage heat exchanger containing a cost-effective and safe ternary eutectic, consisting of sodium chloride, potassium chloride, and sodium carbonate. This material was preliminarily and properly selected and characterized to comply with the necessary melting temperature and latent enthalpy. Then, an indirect heat exchanger was considered for the simulation, assuming aluminum capsules to confine the PCM, thus obtaining the maximum possible heat exchange surface and air at 5 bar as heat transfer fluid (HTF). The modelling was carried out setting the inlet and outlet air temperatures at, respectively, 290 °C and 550 °C, obtaining a realistic storage efficiency of around 0.6. Finally, a conservative investment cost was estimated for the storage system, demonstrating a real possible economic benefit in using these types of materials and heat exchange geometries, with the results varying, according to possible manufacturing prices, in a range from 25 to 40 EUR/kWh.

No abstract

Different fluid compositions have been considered as heat transfer fluids (HTF) for concentrating solar power (CSP) applications. In linear focusing CSP systems synthetic oils are prevalently employed; more recently, the use of molten salt mixtures in linear focusing CSP systems has been proposed too. This paper presents a comparative assessment of thermal oils and five four nitrate/nitrite mixtures, among the ones mostly employed or proposed so far for CSP applications. The typical medium-size CSP plant (50 MWe) operating with synthetic oil as HTF and the “solar salt” as TES was considered as a benchmark. In the first part of the paper, physical properties and operation ranges of different HTFs are reviewed; corrosion and environmental issues are highlighted too. Besides an extensive review of HTFs based on data available from the open literature, the authors report their own obtained experimental data needed to thoroughly compare different solutions. In the second part of the paper, the impact of the different HTF options on the design and operation of CSP plants are analyzed from techno-economic perspectives.