Magnetically compressed plasmas initiated by a double planar wire array (DPWA) are efficient radiation sources. The two rows in a DPWA implode independently and then merge together at stagnation producing soft x-ray yields and powers of up to 11.5kJ∕cm and more than 0.4TW∕cm, higher than other planar arrays or low wire-number cylindrical arrays on the 1MA Zebra generator. DPWA, where precursors form in two stages, produce a shaped radiation pulse and radiate more energy in the main burst than estimates of implosion kinetic energy. High radiation efficiency, compact size (as small as 3–5mm wide), and pulse shaping show that the DPWA is a potential candidate for ICF and radiation physics research.

No abstract

In the following experiments, we studied implosions of different wire arrays and X-pinches produced on the 1-MA Zebra generator at the University of Nevada, Reno. Diagnostics included both spatially-resolved and time-gated X-ray imaging and spectroscopy, and laser probing. In particular, we compared planar wire arrays, to which little energy could be coupled via the conventional magnetic-to-kinetic conversion mechanism, to cylindrical wire arrays of comparable dimensions and mass. The planar wire arrays were shown to radiate much higher peak power and more energy in subkiloelectronvolt and kiloelectronvolt spectral ranges than cylindrical wire arrays. We tested the theoretical conjecture that enhanced resistivity due to the small-scale inhomogeneity of wire-array plasmas has a major effect on dynamics, energy coupling and radiation performance of wire-array Z-pinches. The study of Al, Alumel, and W cylindrical wire arrays shows a wide variety of characteristic behaviors in plasma implosions discussed hereinafter. Additional experimental results for symmetric and asymmetric, uniform stainless steel, Cu, Mo, combined Al/Mo, Mo/Al, Al/W, W/Al, and Mo/W X-pinches are also presented. New data for the total radiation yield are obtained. The planar structures of X-pinch plasma and the corresponding electron beam was observed for most of X-pinches. The generation of hot spots along original wires positions-cooler than those from the cross-wire region-and arc structures with hot spots between

No abstract

International audienceThis article reports on the joint success of two independent lines of research, each of them being a multi-year international effort. One of these is the development of innovative sources, such as planar wire arrays (PWAs). PWAs turned out to be a prolific radiator, which act mainly as a resistor, even though the physical mechanism of efficient magnetic energy conversion into radiation still remains unclear. We review the results of our extensive studies of PWAs. We also report the new results of the experimental comparison PWAs with planar foil liners (another promising alternative to wire array loads at multi-mega-ampere generators). Pioneered at UNR, the PWA Z-pinch loads have later been tested at the Sandia National Laboratories (SNL) on the Saturn generator, on GIT-12 machine in Russia, and on the QiangGuang-1 generator in China, always successfully. Another of these is the drastic improvement in energy efficiency of pulsed-power systems, which started in early 1980s with Zucker's experiments at Naval Research Laboratory (NRL). Successful continuation of this approach was the Load Current Multiplier (LCM) proposed by Chuvatin in collaboration with Rudakov and Weber from NRL. The 100 ns LCM was integrated into the Zebra generator, which almost doubled the plasma load current, from 0.9 to 1.7 MA. The two above-mentioned innovative approaches were used in combination to produce a new compact hohlraum radiation source for ICF, as jointly proposed by SNL and UNR [Jones et al., Phys. Rev. Lett. 104, 125001 (2010)]. The first successful proof-of-the-principle experimental implementation of new hohlraum concept at university-scale generator Zebra/LCM is demonstrated. A numerical simulation capability with VisRaD code (from PRISM Co.) established at UNR allowed for the study of hohlraum coupling physics and provides the possibility of optimization of a new hohlraum. Future studies are discussed