We report a method for fabricating fiber Bragg gratings (FBG) resistant to very severe environments mixing high radiation doses (up to 3 MGy) and high temperatures (up to 230°C). Such FBGs have been written in two types of radiation resistant optical fibers (pure-silica and fluorine-doped cores) by exposures to a 800 nm femtosecond IR laser at power exceeding 500 mW and then subjected to a thermal annealing treatment of 15 min at 750°C. Under radiation, our study reveals that the radiation induced Bragg wavelength shift (BWS) at a 3 MGy dose is strongly reduced compared to responses of FBGs written with nonoptimized conditions. The BWS remains lower than 10 pm for temperatures of irradiation ranging from 25°C to 230°C without noticeable decrease of the FBG peak amplitude. For an applicative point of view, this radiation induced BWS corresponds to an additional error on the temperature measurements lower than 1.5°C, opening the way to the development of radiation-tolerant multi-point temperature sensors for nuclear industry.

Vulnerability of Optical Frequency Domain Reflectometry (OFDR) based sensors to high γ-ray doses (up to 10 MGy) is evaluated with a specific issue of a radiation-hardened temperature and strain monitoring system for nuclear industry. For this, we characterize the main radiation effects that are expected to degrade the sensor performances in such applicative domain: the radiation-induced attenuation (RIA), the possible evolution with the dose of the Rayleigh scattering phenomenon as well as its dependence on temperature and strain. This preliminary investigation is done after the irradiation and for five different optical fiber types covering the range from radiation-hardened fibers to highly radiation sensitive ones. Our results show that at these high dose levels the scattering mechanism at the basis of the used technique for the monitoring is unaffected (changes below 5%), authorizing acceptable precision on the temperature or strain measurements. RIA has to be considered as it limits the sensing range. From our vulnerability study, the OFDR sensors appear as promising candidates for nuclear industry even at doses as high as 10 MGy.

International audienceWe investigate the response of Ge-doped, P-doped, pure-silica, or Fluorine-doped fibers to extreme environments combining doses up to MGy(SiO $_{{{2}}}$) level of 10 keV X-rays and temperatures between 25 C and 300 C . First, we evaluate their potential to serve either as parts of radiation tolerant optical or optoelectronic systems or at the opposite, for the most sensitive ones, as punctual or distributed dosimeters. Second, we improve our knowledge on combined ionizing radiations and temperature (R&T) effects on radiation-induced attenuation (RIA) by measuring the RIA spectra in the ultraviolet and visible domains varying the R&T conditions. Our results reveal the complex response of the tested fibers in such mixed environments. Increasing the temperature of irradiation increases or decreases the RIA values measured at 25C or sometimes has no impact at all. Furthermore, R&T effects are time dependent giving an impact of the temperature on RIA that evolves with the time of irradiation. The two observed transient and stationary regimes of temperature influence will make it very difficult to evaluate sensor vulnerability or the efficiency of hardening approaches without extensive test campaign

The acoustic detection of defects or leaks inside a cylindrical shell containing a fluid is of prime importance in the industry, particularly in the nuclear field. This paper examines the beamforming technique which is used to detect and locate the presence of an acoustic monopole inside a cylindrical elastic shell by measuring the external shell vibrations. In order to study the effect of fluid-structure interactions and the distance of the source from the array of sensors, a vibro-acoustic model of the fluid-loaded shell is first considered for numerical experiments. The beamforming technique is then applied to radial velocities of the shell calculated with the model. Different parameters such as the distance between sensors, the radial position of the source, the damping loss factor of the shell, or of the fluid, and modifications of fluid properties can be considered without difficulty. Analysis of these different results highlight how the behaviour of the fluid-loaded shell influences the detection. PFinally, a test in a water-filled steel pipe is achieved for confirming experimentally the interest of the presented approach. -IntroductionThe fast and reliable detection of acoustic sources in complex industrial cylinder systems is of capital interest since such sources can be the consequence of defects or leaks in the installation. In the nuclear field, for example, a leak in a Steam Generator Unit (SGU) of a sodium fast nuclear reactor induces a water-sodium reaction. This reaction can damage the component. The purpose of this paper is to study the possibility of using a passive vibroacoustic method to detect and locate the noise generated by a water-sodium reaction of leak rate inferior to 1 g H2O /s. Different studies focussing on active and passive detection techniques have been published in the past [1][2][3]. The paper written by Kim et al. [4] focusses on characterising the acoustic noise spectra of different water-into-sodium leaks for a small flow rates (<1 g H2O /s). Chikazawa [5] developed a beamforming method to detect a leak at a frequency of 10 kHz assuming that it emits a planar acoustic field. This assumption, which is reasonable in the high frequency domain, necessitates a high number of sensors to cover the whole steam generator. Sing and Rao [6] looked at detecting a water injection into liquid sodium by measuring the acoustic field radiated by the installation with microphones located far from the system. Such a method is very simple but may be easily disturbed by external acoustic sources. Moreover, it may be useful for detecting leaks of flow rate strong enough to come out of the background noise. In the 1980's, Greene et. al developed a beamforming passive vibro-acoustic method called GAAD to detect and locate a sodium-water reaction in a SGU of a sodium-cooled fast nuclear reactor [7][8][9]. In these papers, authors characterized with an experiment the performance of the localization and the detection time against the leak rate and the SGU power level. These papers show that ...

We investigated point defects induced in rad-hard Fluorine-doped optical fibers using both a mixed source of neutrons (fluences from 1015 to 1017 n/cm2) and γ-rays (doses from 0.02 to 2 MGy) and by a γ-ray source (dose up to 10 MGy). By combining several complementary spectroscopic techniques such as radiation-induced attenuation, confocal micro-luminescence, time-resolved photo-luminescence and electron paramagnetic resonance, we evidenced intrinsic and hydrogen-related defects. The comparison between the two irradiation sources highlights\ud close similarities among the spectroscopic properties of the induced defects and the linear correlation of their concentration up to 1016 n/cm2. These results are interpreted on the basis of the generation processes of defects from precursors sites, that are common to both γ-rays and neutrons. In contrast, the highest neutron fluence (1017 n/cm2) causes peculiar effects, such as the growth of a photoluminescence and variations of the spectral and decay properties of the emission related with nonbridging oxygen hole centers, that are likely due to silica network modification