The oxygen reduction reaction (ORR) is a fundamental reaction for energy storage and conversion. It has mainly relied on platinum-based electrocatalysts, but the chemical doping of carbon-based materials has proven to be a promising strategy for preparing metal-free alternatives. Nitrogen doping in particular provides a diverse range of nitrogen forms. Here, we introduce a new form of nitrogen doping moieties -sp-hybridized nitrogen (sp-N) atoms into chemically defined sites of ultrathin graphdiyne, through pericyclic replacement of the acetylene groups. The as-prepared sp-N-doped graphdiyne catalyst exhibits overall good ORR performance, in particular with regards to peak potential, half-wave potential and current density. Under alkaline conditions it was comparable to commercial Pt/C, and showed more rapid kinetics. And although its performances are a bit lower than those of Pt/C in acidic media they surpass those of other metal-free materials. Taken together, experimental data and density functional theory calculations suggest that the high catalytic activity originates from the sp-N dopant, which facilitates O adsorption and electron transfer on the surface of the catalyst. This incorporation of chemically defined sp-N atoms provides a new synthetic route to high-performance carbon-based and other metal-free catalysts.

Sulfur-doped graphene quantum dots (S-GQDs) with stable blue-green fluorescence were synthesized by one-step electrolysis of graphite in sodium p-toluenesulfonate aqueous solution. Compared with GQDs, the S-GQDs drastically improved the electronic properties and surface chemical reactivities, which exhibited a sensitive response to Fe(3+). Therefore, the S-GQDs were used as an efficient fluorescent probe for highly selective detection of Fe(3+). Upon increasing of Fe(3+) concentration ranging from 0.01 to 0.70 μM, the fluorescence intensity of S-GQDs gradually decreased and reached a plateau at 0.90 μM. The difference in the fluorescence intensity of S-GQDs before and after adding Fe(3+) was proportional to the concentration of Fe(3+), and the calibration curve displayed linear regions over the range of 0-0.70 μM. The detection limit was 4.2 nM. Finally, this novel fluorescent probe was successfully applied to the direct analysis of Fe(3+) in human serum, which presents potential applications in clinical diagnosis and may open a new way to the design of effective fluorescence probes for other biologically related targets.

Conjugated backbones play a fundamental role in determining the electronic properties of organic semiconductors. On the basis of two solution-processable dihydropyrrolo[3,4-c]pyrrole-1,4-diylidenebis(thieno[3,2-b]thiophene) derivatives with aromatic and quinoid structures, we have carried out a systematic study of the relationship between the conjugated-backbone structure and the thermoelectric properties. In particular, a combination of UV-vis-NIR spectra, photoemission spectroscopy, and doping optimization are utilized to probe the interplay between energy levels, chemical doping, and thermoelectric performance. We found that a moderate change in the conjugated backbone leads to varied doping mechanisms and contributes to dramatic changes in the thermoelectric performance. Notably, the chemically doped A-DCV-DPPTT, a small molecule with aromatic structure, exhibits an electrical conductivity of 5.3 S cm and a high power factor (PF) up to 236 μW m K, which is 50 times higher than that of Q-DCM-DPPTT with a quinoid structure. More importantly, the low thermal conductivity enables A-DCV-DPPTT to possess a figure of merit (ZT) of 0.23 ± 0.03, which is the highest value reported to date for thermoelectric materials based on organic small molecules. These results demonstrate that the modulation of the conjugated backbone represents a powerful strategy for tuning the electronic structure and mobility of organic semiconductors toward a maximum thermoelectric performance.

Strategies for selectively imaging and delivering drugs to tumours typically leverage differentially upregulated surface molecules on cancer cells. Here, we show that intravenously injected carbon quantum dots, functionalized with multiple paired α-carboxyl and amino groups that bind to the large neutral amino acid transporter 1 (which is expressed in most tumours), selectively accumulate in human tumour xenografts in mice and in an orthotopic mouse model of human glioma. The functionalized quantum dots, which structurally mimic large amino acids and can be loaded with aromatic drugs through π-π stacking interactions, enabled-in the absence of detectable toxicity-near-infrared fluorescence and photoacoustic imaging of the tumours and a reduction in tumour burden after the targeted delivery of chemotherapeutics to the tumours. The versatility of functionalization and high tumour selectivity of the quantum dots make them broadly suitable for tumour-specific imaging and drug delivery.

It is critically important to develop actuator systems for diverse needs ranging from robots and sensors to memory chips. The advancement of mechanical actuators depends on the development of new materials and rational structure design. In this study, we have developed a novel graphene electrochemical actuator based on a rationally designed monolithic graphene film with asymmetrically modified surfaces. Hexane and O(2) plasma treatment were applied to the opposite sides of graphene film to induce the asymmetrical surface properties and hence asymmetrical electrochemical responses, responsible for actuation behaviors. The newly designed graphene actuator demonstrated here opens a new way for actuator fabrication and shows the potential of graphene film for applications in various electromechanical systems.