Eco‐friendly and low‐cost cellulose nanofiber paper (nanopaper) is a promising candidate as a novel substrate for flexible electron device applications. Here, a thin transparent nanopaper‐based high‐mobility organic thin‐film transistor (OTFT) array is demonstrated for the first time. Nanopaper made from only native wood cellulose nanofibers has excellent thermal stability (>180 °C) and chemical durability, and a low coefficient of thermal expansion (CTE: 5–10 ppm K‐1). These features make it possible to build an OTFT array on nanopaper using a similar process to that for an array on conventional glass. A short‐channel bottom‐contact OTFT is successfully fabricated on the nanopaper by a lithographic and solution‐based process. Owing to the smoothness of the cast‐coated nanopaper surface, a solution processed organic semiconductor film on the nanopaper comprises large crystalline domains with a size of approximately 50–100 μm, and the corresponding TFT exhibits a high hole mobility of up to 1 cm2V‐1 s‐1 and a small hysteresis of below 0.1 V under ambient conditions. The nanopaper‐based OTFT also had excellent flexibility and can be formed into an arbitrary shape. These combined technologies of low‐cost and eco‐friendly paper substrates and solution‐based organic TFTs are promising for use in future flexible electronics application such as flexible displays and sensors.

No abstract

No abstract

In angle-multiplexed holographic memory, the full width at half maximum of the Bragg selectivity curves is dependent on the angle formed between the medium and incident laser beams. This indicates the possibility of high density and high multiplexing number by varying the angular intervals between adjacent holograms. We propose an angular interval scheduling for closely stacking holograms into medium even when the angle range is limited. We obtained bit error rates of the order of 10 À4 under the following conditions: medium thickness of 1 mm, laser beam wavelength of 532 nm, and angular multiplexing number of 300.

Photopolymer materials shrink because of photopolymerization. This shrinkage distorts the recorded interference fringes in a medium made of such material, which in turn degrades the reconstructed image quality. Adaptive optics controlled by a genetic algorithm was developed to optimize the wavefront of the reference beam while reproducing in order to compensate for the interference fringe distortion. We defined a fitness measure for this genetic algorithm that involves the mean brightness and coefficients of the variations of bit data "1" and "0". In an experiment, the adaptive optics improved the reconstructed image to the extent that data could be reproduced from the entire area of the image, and the signal to noise ratio of the reproduced data could be improved.