We introduce the 2D counterpart of layered black phosphorus, which we call phosphorene, as an unexplored p-type semiconducting material. Same as graphene and MoS2, single-layer phosphorene is flexible and can be mechanically exfoliated. We find phosphorene to be stable and, unlike graphene, to have an inherent, direct, and appreciable band gap. Our ab initio calculations indicate that the band gap is direct, depends on the number of layers and the in-layer strain, and is significantly larger than the bulk value of 0.31-0.36 eV. The observed photoluminescence peak of single-layer phosphorene in the visible optical range confirms that the band gap is larger than that of the bulk system. Our transport studies indicate a hole mobility that reflects the structural anisotropy of phosphorene and complements n-type MoS2. At room temperature, our few-layer phosphorene field-effect transistors with 1.0 μm channel length display a high on-current of 194 mA/mm, a high hole field-effect mobility of 286 cm(2)/V·s, and an on/off ratio of up to 10(4). We demonstrate the possibility of phosphorene integration by constructing a 2D CMOS inverter consisting of phosphorene PMOS and MoS2 NMOS transistors.

Phosphorene, an elemental 2D material, which is the monolayer of black phosphorus, has been mechanically exfoliated recently. In its bulk form, black phosphorus shows high carrier mobility (~10000 cm 2 /V· s) and a ~0.3 eV direct bandgap. Well-behaved p-type field-effect transistors with mobilities of up to 1000 cm 2 /V· s, as well as phototransistors, have been demonstrated on few-layer black phosphorus, showing its promise for electronics and optoelectronics applications due to its high hole mobility and thickness-dependence direct bandgap. However, p-n junctions, the basic building blocks of modern electronic and optoelectronic devices, have not yet been realized based on black phosphorus. In this paper, we demonstrate a gate tunable p-n diode based on a p-type black phosphorus/n-type monolayer MoS2 van der Waals p-n heterojunction. Upon illumination, these ultra-thin p-n diodes show a maximum photodetection responsivity of 418 mA/W at the wavelength of 633 nm, and photovoltaic energy conversion with an external quantum efficiency of 0.3%. These p-n diodes show promise for broadband photodetection and solar energy harvesting.Key words: black phosphorus, phosphorene, MoS2, p-n diode, van der Waals heterojunction, photodetection, solar cell 3 The successful isolation of graphene from graphite has led to its extensive study in physics, materials, and nano-engineering due to its extraordinary electrical and mechanical properties. [1][2][3][4] However, a lack of a bandgap limits its potential for electronic device applications, and has inspired the exploration of other 2D layered materials. [5][6][7] Among them, transition metal dichalcogenides (TMDCs), such as MoS2, are the most studied materials. [8][9][10][11] Recently, phosphorene, the monolayer form of black phosphorus, has been successfully isolated. 12 Analogous to graphite and graphene, black phosphorus is a stack of phosphorene monolayers, bound together by van der Waals interactions. 12,13 Bulk black phosphorus shows a ~0.3 eV direct bandgap and a mobility of up to ~10000 cm 2 /V· s. 14-17 Its bandgap increases as its thickness decreases, and is predicted to have a >1 eV direct bandgap in its monolayer form. 12,13 Well-behaved p-type field-effect transistors with mobilities of up to 1000 cm 2 /V· s, as well as inverters, have been demonstrated on few-layer black phosphorus. 12,13,[18][19][20] Based on its direct bandgap, few-layer black phosphorus phototransistors have been demonstrated with a responsivity of 4.8 mA/W. 19 These results indicate that black phosphorus is a promising candidate for both high performance electronics and optoelectronics applications due to its ultra-thin 2D nature, high hole mobility, and narrower direct bandgap compared to most of TMDCs. P-N junctions are the basic building blocks of modern semiconductor devices, including diodes, bipolar transistors, photodiodes, light-emitting diodes, and solar cells. In the conventional p-n homo-junction, the p-and n-type regions are formed by 4 chemically doping a bulk semiconduct...

No abstract