Simutaneously high open circuit voltage and high short circuit current density is a big challenge for achieving high efficiency polymer solar cells due to the excitonic nature of organic semdonductors. Herein, we developed a trialkylsilyl substituted 2D-conjugated polymer with the highest occupied molecular orbital level down-shifted by Si–C bond interaction. The polymer solar cells obtained by pairing this polymer with a non-fullerene acceptor demonstrated a high power conversion efficiency of 11.41% with both high open circuit voltage of 0.94 V and high short circuit current density of 17.32 mA cm−2 benefitted from the complementary absorption of the donor and acceptor, and the high hole transfer efficiency from acceptor to donor although the highest occupied molecular orbital level difference between the donor and acceptor is only 0.11 eV. The results indicate that the alkylsilyl substitution is an effective way in designing high performance conjugated polymer photovoltaic materials.

c Direct interspecies electron transfer (DIET) is potentially an effective form of syntrophy in methanogenic communities, but little is known about the diversity of methanogens capable of DIET. The ability of Methanosarcina barkeri to participate in DIET was evaluated in coculture with Geobacter metallireducens. Cocultures formed aggregates that shared electrons via DIET during the stoichiometric conversion of ethanol to methane. Cocultures could not be initiated with a pilin-deficient G. metallireducens strain, suggesting that long-range electron transfer along pili was important for DIET. Amendments of granular activated carbon permitted the pilin-deficient G. metallireducens isolates to share electrons with M. barkeri, demonstrating that this conductive material could substitute for pili in promoting DIET. When M. barkeri was grown in coculture with the H 2 -producing Pelobacter carbinolicus, incapable of DIET, M. barkeri utilized H 2 as an electron donor but metabolized little of the acetate that P. carbinolicus produced. This suggested that H 2 , but not electrons derived from DIET, inhibited acetate metabolism. P. carbinolicus-M. barkeri cocultures did not aggregate, demonstrating that, unlike DIET, close physical contact was not necessary for interspecies H 2 transfer. M. barkeri is the second methanogen found to accept electrons via DIET and the first methanogen known to be capable of using either H 2 or electrons derived from DIET for CO 2 reduction. Furthermore, M. barkeri is genetically tractable, making it a model organism for elucidating mechanisms by which methanogens make biological electrical connections with other cells.

Low bandgap n-type organic semiconductor (n-OS) ITIC has attracted great attention for the application as an acceptor with medium bandgap p-type conjugated polymer as donor in nonfullerene polymer solar cells (PSCs) because of its attractive photovoltaic performance. Here we report a modification on the molecular structure of ITIC by side-chain isomerization with meta-alkyl-phenyl substitution, m-ITIC, to further improve its photovoltaic performance. In a comparison with its isomeric counterpart ITIC with para-alkyl-phenyl substitution, m-ITIC shows a higher film absorption coefficient, a larger crystalline coherence, and higher electron mobility. These inherent advantages of m-ITIC resulted in a higher power conversion efficiency (PCE) of 11.77% for the nonfullerene PSCs with m-ITIC as acceptor and a medium bandgap polymer J61 as donor, which is significantly improved over that (10.57%) of the corresponding devices with ITIC as acceptor. To the best of our knowledge, the PCE of 11.77% is one of the highest values reported in the literature to date for nonfullerene PSCs. More importantly, the m-ITIC-based device shows less thickness-dependent photovoltaic behavior than ITIC-based devices in the active-layer thickness range of 80-360 nm, which is beneficial for large area device fabrication. These results indicate that m-ITIC is a promising low bandgap n-OS for the application as an acceptor in PSCs, and the side-chain isomerization could be an easy and convenient way to further improve the photovoltaic performance of the donor and acceptor materials for high efficiency PSCs.

Non-fullerene polymer solar cells (PSCs) with solution-processable n-type organic semiconductor (n-OS) as acceptor have seen rapid progress recently owing to the synthesis of new low bandgap n-OS, such as ITIC. To further increase power conversion efficiency (PCE) of the devices, it is of a great challenge to develop suitable polymer donor material that matches well with the low bandgap n-OS acceptors thus providing complementary absorption and nanoscaled blend morphology, as well as suppressed recombination and minimized energy loss. To address this challenge, we synthesized three medium bandgap 2D-conjugated bithienyl-benzodithiophene-alt-fluorobenzotriazole copolymers J52, J60, and J61 for the application as donor in the PSCs with low bandgap n-OS ITIC as acceptor. The three polymers were designed with branched alkyl (J52), branched alkylthio (J60), and linear alkylthio (J61) substituent on the thiophene conjugated side chain of the benzodithiophene (BDT) units for studying effect of the substituents on the photovoltaic performance of the polymers. The alkylthio side chain, red-shifted absorption down-shifted the highest occupied molecular orbital (HOMO) level and improved crystallinity of the 2D conjugated polymers. With linear alkylthio side chain, the tailored polymer J61 exhibits an enhanced JSC of 17.43 mA/cm(2), a high VOC of 0.89 V, and a PCE of 9.53% in the best non-fullerene PSCs with the polymer as donor and ITIC as acceptor. To the best of our knowledge, the PCE of 9.53% is one of the highest values reported in literature to date for the non-fullerene PSCs. The results indicate that J61 is a promising medium bandgap polymer donor in non-fullerene PSCs.