Molybdenum disulfide (MoS2) is a promising nonprecious catalyst for the hydrogen evolution reaction (HER) that has been extensively studied due to its excellent performance, but the lack of understanding of the factors that impact its catalytic activity hinders further design and enhancement of MoS2-based electrocatalysts. Here, by using novel porous (holey) metallic 1T phase MoS2 nanosheets synthesized by a liquid-ammonia-assisted lithiation route, we systematically investigated the contributions of crystal structure (phase), edges, and sulfur vacancies (S-vacancies) to the catalytic activity toward HER from five representative MoS2 nanosheet samples, including 2H and 1T phase, porous 2H and 1T phase, and sulfur-compensated porous 2H phase. Superior HER catalytic activity was achieved in the porous 1T phase MoS2 nanosheets that have even more edges and S-vacancies than conventional 1T phase MoS2. A comparative study revealed that the phase serves as the key role in determining the HER performance, as 1T phase MoS2 always outperforms the corresponding 2H phase MoS2 samples, and that both edges and S-vacancies also contribute significantly to the catalytic activity in porous MoS2 samples. Then, using combined defect characterization techniques of electron spin resonance spectroscopy and positron annihilation lifetime spectroscopy to quantify the S-vacancies, the contributions of each factor were individually elucidated. This study presents new insights and opens up new avenues for designing electrocatalysts based on MoS2 or other layered materials with enhanced HER performance.

Lacking strategies to simultaneously address the intrinsic activity, site density, electrical transport, and stability problems of chalcogels is restricting their application in catalytic hydrogen production. Herein, we resolve these challenges concurrently through chemically activating the molybdenum disulfide (MoS2) surface basal plane by doping with a low content of atomic palladium using a spontaneous interfacial redox technique. Palladium substitution occurs at the molybdenum site, simultaneously introducing sulfur vacancy and converting the 2H into the stabilized 1T structure. Theoretical calculations demonstrate the sulfur atoms next to the palladium sites exhibit low hydrogen adsorption energy at –0.02 eV. The final MoS2 doped with only 1wt% of palladium demonstrates exchange current density of 805 μA cm−2 and 78 mV overpotential at 10 mA cm−2, accompanied by a good stability. The combined advantages of our surface activating technique open the possibility of manipulating the catalytic performance of MoS2 to rival platinum.

Semiconductor photocatalysis attracts widespread interest in water splitting, CO reduction, and N fixation. N reduction to NH is essential to the chemical industry and to the Earth's nitrogen cycle. Industrially, NH is synthesized by the Haber-Bosch process under extreme conditions (400-500 °C, 200-250 bar), stimulating research into the development of sustainable technologies for NH production. Herein, this study demonstrates that ultrathin layered-double-hydroxide (LDH) photocatalysts, in particular CuCr-LDH nanosheets, possess remarkable photocatalytic activity for the photoreduction of N to NH in water at 25 °C under visible-light irradiation. The excellent activity can be attributed to the severely distorted structure and compressive strain in the LDH nanosheets, which significantly enhances N chemisorption and thereby promotes NH formation.