Undetected short circuit faults are a significant problem in power transformers and can eventually develop into catastrophic faults. At present, frequency response analysis (FRA) is one of the well-recognized diagnostic tools for the detection of winding faults, but it has some limitations, such as a low signal-to-noise ratio (SNR) and instability caused by changes in the measuring voltage. In this paper, a novel method called sweep frequency impedance (SFI) is proposed to address the difficulties that arise from FRA. Based on the mechanism of this new method, a nondestructive testing system was established to demonstrate the advantages of SFI measurements. The SFI test system has a better stability, repeatability, and SNR by comparing it with the FRA test system. Moreover, FRA and SFI curves obtained under the same conditions was symmetrical about a specific straight line above 10 kHz, and the SFI value at 50 Hz is equivalent to the short circuit impedance (SCI) value of a transformer. These results indicate that the existing criteria of FRA and SCI methods can be used in the SFI method to detect transformer faults. Finally, the experiments on a special oil-immersed testing transformer demonstrate that the SFI detection system is feasible, sufficiently sensitive to detect short circuit faults and able to quantify the level of the fault.Index Terms -Transformer winding deformation, frequency response analysis (FRA), short circuit impedance (SCI), sweep frequency impedance (SFI), short circuit fault.

Research on aging characteristics of epoxy resin (EP) under repetitive microsecond pulses is important for the design of insulating materials in high power apparatus. It is because that very fast transient overvoltage always occurs in a power system, which causes flashover and is one of the main factors causing aging effects of EP materials. Therefore, it is essential to obtain a better understanding of the aging effect on an EP surface resulting from flashover. In this work, aging effects on an EP surface were investigated by surface flashover discharge under repetitive microsecond pulses in atmospheric pressure. The investigations of parameters such as the surface micro-morphology and chemical composition of the insulation material under different degrees of aging were conducted with the aid of measurement methods such as atomic force microscopy (AFM), scanning electron microscopy (SEM), and X-ray photoelectron spectroscopy (XPS). Results showed that with the accumulation of aging energy on the material surface, the particles formed on the material surface increased both in number and size, leading to the growth of surface roughness and a reduction in the water contact angle; the surface also became more absorbent. Furthermore, in the aging process, the molecular chains of EP on the surface were broken, resulting in oxidation and carbonisation.

No abstract

No abstract

No abstract