A Bidirectional Neural Interface IC With Chopper Stabilized BioADC Array and Charge Balanced Stimulator

Abstract

We present a bidirectional neural interface with a 4-channel biopotential analog-to-digital converter (bioADC) and a 4-channel current-mode stimulator in 180nm CMOS. The bioADC directly transduces microvolt biopotentials into a digital representation without a voltage-amplification stage. Each bioADC channel comprises a continuous-time first-order ΔΣ modulator with a chopper-stabilized OTA input and current feedback, followed by a second-order comb-filter decimator with programmable oversampling ratio. Each stimulator channel contains two independent digital-to-analog converters for anodic and cathodic current generation. A shared calibration circuit matches the amplitude of the anodic and cathodic currents for charge balancing. Powered from a 1.5V supply, the analog and digital circuits in each recording channel draw on average 1.54 μA and 2.13 μA of supply current, respectively. The bioADCs achieve an SNR of 58 dB and a SFDR of >70 dB, for better than 9-b ENOB. Intracranial EEG recordings from an anesthetized rat are shown and compared to simultaneous recordings from a commercial reference system to validate performance in-vivo. Additionally, we demonstrate bidirectional operation by recording cardiac modulation induced through vagus nerve stimulation, and closed-loop control of cardiac rhythm. The micropower operation, direct digital readout, and integration of electrical stimulation circuits make this interface ideally suited for closed-loop neuromodulation applications.

A 14-ENOB Delta-Sigma-Based Readout Architecture for ECoG Recording Systems

“…Compared to the SNDR expression from [28], in (8) we also include the linearity performance of the system. The assumption is that the THD is primarily dominated by the third order harmonic, which is a reasonable assumption for a differential architecture, but, also optimistic since it neglects the existence of other harmonics.…”

Highly Configurable 100 Channel Recording and Stimulating Integrated Circuit for Biomedical Experiments

“…The recording channel is dedicated to performing proper amplification and filtration of weak input biomedical signals to optimally utilize allowable supply voltage and to condition signals for following blocks, such as analog to digital converters. There are many excellent examples of integrated electronics dedicated to biomedical signals recordings [27][28][29][30][31][32][33][34]. These very often utilize additional techniques to overcome problems with noise and power consumption (such as chopping, sigma-delta conversion, ad digital feedback), and promoted results are outstanding.…”

A Fully Integrated 64-Channel Recording System for Extracellular Raw Neural Signals

“…The DC offset between two electrodes should be of concern as well, which is typically tens of millivolts [8,10,16], but is sometimes as large as 1-2 V [1,3,13]. To avoid saturation due to such a large offset, the recording system usually has the input stage of high-pass filtering, which may be dc-coupled with a feedback low-pass filter [9,12,15,16,20] or ac-coupled with an input capacitor [1][2][3][4][5][6][7][8][17][18][19][21][22][23][24][25][26][27][28]. Without additional power, the ac-coupled method is passive and easier to achieve.…”