A comparative study between a Rankine cycle and a novel intra-cycle based waste heat recovery concepts applied to an internal combustion engine

Abstract

A novel intra-cycle waste heat recovery (ICWHR) methodology, applied to an internal combustion engine is presented in this study. Through a split type thermodynamic cycle design, quasi-isothermal compression of the charge air and isobaric combustion of the air/fuel mixture can be performed separately in two chambers. Within such a design, the exhaust heat can be recovered to the intake air flow between the compression chamber and combustion chamber. Consequently, the recovered energy can be re-utilized in the combustor directly, and an intra-cycle waste heat recovery process can be achieved. To investigate the fundamental aspects of this new methodology, a comparative study between the conventional Rankine based WHR and the new ICWHR was undertaken. Both theoretical and numerical analysis were applied to evaluate the performance characteristics of these two technologies. The ICWHR cycle differs from the Rankine cycle in that an energy conversion subsystem is not necessary since the recovered energy is sent back to the combustion chamber directly, and then the system efficiency is improved significantly. Furthermore, the theoretical results indicate that the full cycle efficiency of ICWHR system is determined by the regeneration effectiveness, the compression ratio and the fuel equivalence ratio, then the limitations of Rankine cycle, such as working fluid selection and system parameter calibration can be avoided mechanically. Finally, through a one dimensional system model, analysis of optimal operation range, system efficiency and the heat transfer behaviours of ICWHR system are discussed in this paper and comparisons made with a Rankine cycle WHR syste

Starting to Unpick the Unique Air–Fuel Mixing Dynamics in the Recuperated Split Cycle Engine

“…The novelty of the RSCE, compared to other SCEs, is that the crossover pipe utilises a recuperator (a heat exchanger). Waste heat from the exhaust is recovered to heat the charge air after compression but pre-combustion, which has been shown to be more efficient than recovery post-combustion using a Rankine cycle [22]. This concept is referred to as Dry Thermopower.…”

Domestic thermoelectric cogeneration system optimization analysis, energy consumption and CO2 emissions reduction

“…Heat lost in mechanical systems is usually through exhaust gases as in boilers [11][12][13][14], heat pump [15,16], industrial furnace [17,18], generators [19][20][21], internal combustion engines (ICE) [22][23][24][25][26][27][28], chimneys [29,30], and other applications [31][32][33][34][35] or by heating, ventilating, and air conditioning (HVAC) systems [36,37], and hot water [38][39][40][41][42]. Hossain and Bari [43] performed an experimental study on heat recovery from exhaust gases of a 40 kW diesel generator using different organic fluids.…”

Evaluation of the Economic Efficiency of Heat Recovery From Exhaust Gas of Diesel Power Plants in Kazakhstan

“…One of the key tasks of achieving economic efficiency in the modern energy sector is to increase the production of electricity at thermal power plants through the use of non-traditional energy sources (Bhowmik et al, 2018;Akhmetshin et al, 2019;Kozhakhmetova et al, 2019). Combined technologies using waste heat of exhaust gases have great potential in the reconstruction This Journal is licensed under a Creative Commons Attribution 4.0 International License of old and the design of new diesel and gas turbine power plants (Robb, 2011;Morgan et al, 2016).…”