A DFT study of SenTenclusters

Sharma, Tamanna; Sharma, Raman; Kanhere, D. G.

doi:10.1039/d1na00321f

Cited by 6 publications

(1 citation statement)

References 87 publications

(205 reference statements)

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The observed rise in conductivity finds its explanation within the framework of the bond energies between Se, Te, and Bi atoms. , There is a preference for heteropolar bonds over homopolar bonds inside the matrix. As per the earlier studies, the introduction of Te into the Se-rich system leads to the creation of Se 6 Te 2 rings at the expense of Se 8 rings. ,− The study by J. Schottmiller discusses and provides evidence for the presence of Se 6 Te 2 rings through Raman spectroscopy in Se-dominated Se–Te alloys . The study reveals the addition of Te introduces a well-defined peak in the Raman spectra along with a peak of the Se 8 ring, which can be attributed to a mixed octa-atomic ring, predicted to be Se 6 Te 2 .…”

Section: Resultsmentioning

confidence: 76%

Peculiarities of Electrical Switching and Phase Transition Dynamics in Bismuth-Infused Se–Te Chalcogenide Glasses: From Bulk to Thin Film Devices

Joshi,

Rodney,

N. K.

2024

ACS Appl. Electron. Mater.

View full text Add to dashboard Cite

Herein, the electrical switching behavior of both bulk and thin film forms of Se86–x Te14Bi x (0 ≤ x ≤ 4) chalcogenide glasses was investigated. The melt–quench-derived glasses were found to be amorphous, and the switching behavior exhibited a threshold-type response below a certain current limit (I th) for bismuth (Bi)-doped bulk samples. Interestingly, as current levels surpassed this threshold, a noteworthy change occurred in the switching behavior, converting it into a memory-type response. The threshold voltage (V th) exhibited a decreasing trend from ∼228 V to ∼36 V with an increasing Bi content, and differential scanning calorimetry (DSC) was utilized to study the phase transition phenomena and thermal stability of the amorphous glasses. These DSC results unequivocally confirmed that the transition from amorphous to crystalline phase occurred readily and at lower temperatures in the Se82Te14Bi4 composition. Furthermore, annealing studies were carried out to gain insight into the phase transformations that occur when the material makes the transition from an amorphous to a crystalline state. Subsequently, the same melt–quench-derived glasses were deposited as a thin film using physical vapor deposition (PVD) into a three-layered Al/Se–Te–Bi/Al device, and the memory switching voltage experienced a remarkable drop to 2.88 V compared to the bulk material. This exploration sheds light on the captivating electrical switching behavior of Se86–x Te14Bi x chalcogenide glasses and holds promise for potential applications spanning the realm of emerging electronics and phase change material (PCM) devices.

show abstract