A hybrid modulation method for lifetime extension of power semiconductors in wind power converters

Abstract

Pulse width modulation (PWM) techniques can be classified into continuous pulse width modulation (CPWM) and discontinuous pulse width modulation (DPWM) types. The switching loss of power devices in DPWM converters is lower than that in CPWM converters. Lower loss could reduce the junction temperature fluctuation in converters of wind turbine generator system (WTGS) and may result in longer power devices lifetime. However, employing DPWM scheme under all WTGS operation conditions will lead to power quality concern. To solve this problem, a new hybrid modulation scheme which combines the CPWM and DPWM methods for WTGS converters is presented in this paper. In the presented hybrid modulation method, two modulation schemes are switched back and forth according to the wind speed in the wind farm site. The performance of the presented modulation scheme is verified and compared with that of other PWM schemes through a case study of 1.2 MW WTGS in long-term mission profiles. The results show that the lifetime of power devices with the presented hybrid approach is longer than that with the CPWM, and is shorter than that with the DPWMs. Moreover, the power quality of the power converters with the hybrid modulation scheme can be guaranteed in all operation conditions, which may not be achieved with DPWMs.

IGBT Gate Boost Drive Technology for Promoting the Overload Capacity of Traction Converter

“…Since the train has four traction motors, the traction force of each motor is about 7.35 kN. According to (6), the output current RMS of the traction inverter is Io = 79.8 A.…”

“…Therefore, the traction force of each motor is about 103.75 kN. According to (6), the output current RMS of the traction inverter is Io = 1126.1 A. However, the rated current of the traction inverter is only 460 A.…”

“…Reduction in IGBT loss, primarily through modulation, system control, and gate drive, is frequently used to control IGBT temperature rise. Several modulation techniques are employed in [ 6 , 7 ] to regulate the IGBT switching sequence and lower the loss of IGBT. However, this technique will produce waveforms with poor quality.…”

A Reactive Power Injection Algorithm for Improving the Microgrid Operational Reliability

“…In [15], a DSVPWM method was introduced to enhance the thermal reliability of a three-level inverter by adjusting the switching modes based on the load power factor. Similarly, the author in [16] proposed an algorithm to change the modulation strategy from DPWM to CPWM based on the probability distribution of wind speed. In [17], the driving voltage of IGBTs was adjusted in a closed loop to mitigate junction temperature ripple.…”