A New Multilevel Inverter Topology with Reduced DC Sources

Abstract

The component count for the multilevel inverter has been a research topic for the last few decades. The higher number of power semiconductor devices and sources leads to a higher power loss with the complex control requirement. A new multilevel inverter topology employing the concept of half-Bridge modules is suggested in this paper. It requires a lower number of dc sources and power components. The inverter is controlled using a fundamental frequency switching scheme. With the basic unit being able to produce 13 level voltage waveforms with three dc voltage sources, higher-level inverter configuration has also been discussed in the paper. The performance of the topology is analyzed in the aspects of circuit parameters and found better when compared to similar topologies proposed in recent literature. The comparison provided in the paper set the benchmark of the proposed topology in terms of lower component requirements. The topology is also optimized with two voltage fixing algorithms for maximizing the number of levels for the given number of IGBTs, drivers and dc sources, and the observations are presented. The efficiency analysis gives the peak efficiency as 98.5%. The simulations were carried out using the PLECS software tool and validated using a prototype rated at 500 W. The results with several test conditions have been reported and discussed in the paper.

Phase Shift APOD and POD Control Technique in Multi-Level Inverters to Mitigate Total Harmonic Distortion

“…The switching table for the eight IGBTs used in the topology is included in this section [25]. This topology is made up of separate parts for generating the level and polarity.…”

A Novel Multilevel Inverter for Renewable Energy Applications with Optimized Controller and Reduced Switches

“…Power electronics and processors play critical roles in current technology in domains such as light management, motor control, power supply, heat control, HVDC, vehicle systems, renewable applications, and FACTS [1]. Power converters with greater operating voltages are to be built with the aid of semiconductor device technology [2]. Multiple devices must connect in series to satisfy the voltage rating because a single device cannot withstand such high voltages [3].…”

“…,2 School of Electrical Engineering, Vellore Institute of Technology, Vellore, India.Email: 1 tejasvibathyala@gmail.com, 2 pvijayapriya@vit.ac.in…”

Solar Photovoltaic System-Based Reduced Switch Multilevel Inverter for Improved Power Quality

“…A new MLI topology using a diode half-bridge circuit is explained in [31]. An MLI where the number of DC sources is reduced with the control of the switching scheme is suggested in [32]. A solar-powered electric vehicle parking lot for the optimal operation with respect to efficiency and cost is suggested in [33].…”