A numerical study on the effect of spanwise installation of vortex generators on Francis runner blades

Abstract

Hydro turbine operation far off from its best efficiency point introduces vortices and swirl that detaches flow from the blade surface. This break-off of flow accounts to loss in hydrodynamic lift accompanied by pressure fluctuations and vibration that leads to poor performance and mechanical failure of the turbine blades. Vortex generators (VGs) are efficient passive devices deployed to enhance aerodynamic lift of wind turbine blades and aircraft wings and can improve hydrodynamic lift on turbine runner blades as well. This study aims to investigate on the possibility of installation of VGs on the runner blade at leading edge, midspan and trailing edge of the runner blade. The study is carried out on a model Francis turbine developed at Waterpower Laboratory, NTNU. The numerical study is mainly focused on improving performance of the turbine at low speed as well as at the best efficiency speed. The operating head selected for the study is 11.94 m and the speed of the turbine is varied from 233 rpm to 433 rpm at an increment of 25 rpm. The turbine is simulated at different positions of guide vanes and hydraulic performance is calculated and the results of the analysis are compared with reference case without VGs. The results at deep-part load show major improvement in runner efficiency with increment in values up to 4%. The core purpose of the research is to develop effective techniques to operate traditional turbine runner at variable speed with cost-efficient minimal modifications in the geometry of the runner blades.