A photocatalytic performance of TiO2 photocatalyst prepared by the hydrothermal method

Nam, Woo Seok; Han, Gui Young

doi:10.1007/bf02697206

Cited by 25 publications

(9 citation statements)

References 12 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In a b c d [112] TiO2-coated rotating disk reactor (RDR) [114] A c c e p t e d M a n u s c r i p t Tubular photocatalytic reactor In this design, 24 pyrex tubes (each piece: 75 cm long and 0.6 cm i.d., total volume: 510ml) have been used. Each end is attached to tygon tubes, which are installed onto a horizontal stainless steel plate (200 cm×100 cm) at the same distance (8 cm) and furthermore the head and tail parts of the combined pyrex tubes are combined with a tygon tube covered black hose.…”

Section: Outmentioning

confidence: 99%

Photocatalytic oxidation of organic dyes and pollutants in wastewater using different modified titanium dioxides: A comparative review

Zangeneh

Zinatizadeh

Habibi

et al. 2015

Journal of Industrial and Engineering Chemistry

603

220

View full text Add to dashboard Cite

Section: Outmentioning

confidence: 99%

Photocatalytic oxidation of organic dyes and pollutants in wastewater using different modified titanium dioxides: A comparative review

Zangeneh

Zinatizadeh

Habibi

et al. 2015

Journal of Industrial and Engineering Chemistry

603

220

View full text Add to dashboard Cite

“…In recent years, many studies have been reported involving the use of TiO 2 -based photocatalyst due to the physical and chemical stability, low cost, non-toxicity and unique electronic and optical properties of titania [1][2][3][4].…”

Section: Introductionmentioning

confidence: 99%

Effect of Fe3+ doping on the performance of TiO2 mechanocoated alumina bead photocatalysts

Bajamundi

Dalida

Wantala

et al. 2011

Korean J. Chem. Eng.

View full text Add to dashboard Cite

Ferric ion was introduced to the commercial photocatalyst P25 (Degussa) by ultrasonic wet impregnation technique. The concentration of the dopant was varied from 0.0 to 3.0% Fe/Ti ratio. The doped TiO 2 was then loaded to alumina balls using mechanical coating technique and followed by calcination in air at 400, 450, 500 and 550 o C. The fabricated photocatalyst was characterized by X-ray diffraction, N 2 adsorption-desorption isotherms, scanning electron microscopy, UV-Vis diffuse reflectance spectroscopy, X-ray adsorption near edge structure and photoluminescence spectroscopy. The photocatalytic activity was tested by following the degradation of methylene blue (MB). It was found that the Fe 3+ doped TiO 2 /Al 2 O 3 has a combination of anatase and rutile phase and free of iron oxide phases. The optimum calcination temperature is 400 o C with 0.1% Fe 3+ concentration. The catalyst addresses the entrainment in photocatalytic reactors, eliminating the need for a post filtration process.

show abstract

“…Nam et al, who obtained TiO 2 in anatase phase at low temperatures [14], reported this hydrothermal treatment.…”

Section: Introductionmentioning

confidence: 90%

TiO<sub>2</sub> Films Synthesis over Polypropylene by Sol-Gel Assisted with Hydrothermal Treatment for the Photocatalytic Propane Degradation

Guzmán-Velderrain¹,

López²,

Gutiérrez³

et al. 2014

GSC

View full text Add to dashboard Cite

A photocatalytic performance of TiO2 photocatalyst prepared by the hydrothermal method

Cited by 25 publications

References 12 publications

Photocatalytic oxidation of organic dyes and pollutants in wastewater using different modified titanium dioxides: A comparative review

Photocatalytic oxidation of organic dyes and pollutants in wastewater using different modified titanium dioxides: A comparative review

Effect of Fe3+ doping on the performance of TiO2 mechanocoated alumina bead photocatalysts

TiO<sub>2</sub> Films Synthesis over Polypropylene by Sol-Gel Assisted with Hydrothermal Treatment for the Photocatalytic Propane Degradation

Contact Info

Product

Resources

About

A photocatalytic performance of TiO2 photocatalyst prepared by the hydrothermal method

Cited by 25 publications

References 12 publications

Photocatalytic oxidation of organic dyes and pollutants in wastewater using different modified titanium dioxides: A comparative review

Photocatalytic oxidation of organic dyes and pollutants in wastewater using different modified titanium dioxides: A comparative review

Effect of Fe3+ doping on the performance of TiO2 mechanocoated alumina bead photocatalysts

TiO&lt;sub&gt;2&lt;/sub&gt; Films Synthesis over Polypropylene by Sol-Gel Assisted with Hydrothermal Treatment for the Photocatalytic Propane Degradation

Contact Info

Product

Resources

About

TiO<sub>2</sub> Films Synthesis over Polypropylene by Sol-Gel Assisted with Hydrothermal Treatment for the Photocatalytic Propane Degradation