A Pilot Study of Impulse Radio Ultra Wideband Radar Technology as a New Tool for Sleep Assessment

Ghaffar

et al. 2020

Sensors

Non-invasive remote health monitoring plays a vital role in epidemiological situations such as SARS outbreak (2003), MERS (2015) and the recently ongoing outbreak of COVID-19 because it is extremely risky to get close to the patient due to the spread of contagious infections. Non-invasive monitoring is also extremely necessary in situations where it is difficult to use complicated wired connections, such as ECG monitoring for infants, burn victims or during rescue missions when people are buried during building collapses/earthquakes. Due to the unique characteristics such as higher penetration capabilities, extremely precise ranging, low power requirement, low cost, simple hardware and robustness to multipath interferences, Impulse Radio Ultra Wideband (IR-UWB) technology is appropriate for non-invasive medical applications. IR-UWB sensors detect the macro as well as micro movement inside the human body due to its fine range resolution. The two vital signs, i.e., respiration rate and heart rate, can be measured by IR-UWB radar by measuring the change in the magnitude of signal due to displacement caused by human lungs, heart during respiration and heart beating. This paper reviews recent advances in IR-UWB radar sensor design for healthcare, such as vital signs measurements of a stationary human, vitals of a non-stationary human, vital signs of people in a vehicle, through the wall vitals measurement, neonate's health monitoring, fall detection, sleep monitoring and medical imaging. Although we have covered many topics related to health monitoring using IR-UWB, this paper is mainly focused on signal processing techniques for measurement of vital signs, i.e., respiration and heart rate monitoring.

Section: Sleep Monitoringmentioning

confidence: 99%

An Overview of Signal Processing Techniques for Remote Health Monitoring Using Impulse Radio UWB Transceiver

Ghaffar

et al. 2020

Sensors

“…Several existing studies also utilize objective measures of sleep, typically employing actigraphy or, to a lesser extent, polysomnography (PSG). The former has generally limited specificity ( Marino et al, 2013 ) and cannot differentiate between sleep stages, whereas PSG suffers from practical drawbacks related to cost, skills, and time, limiting its feasibility in long-term sleep assessment ( Pallesen et al, 2018 ).…”

Section: Introductionmentioning

confidence: 99%

Reciprocal Associations Between Sleep, Mental Strain, and Training Load in Junior Endurance Athletes and the Role of Poor Subjective Sleep Quality

et al. 2020

Self Cite

The importance of adequate sleep for athletic functioning is well established. Still, the literature shows that many athletes report sleep of suboptimal quality or quantity. To date, no research has investigated how bidirectional variations in mental and physiological states influence sleep patterns. The present study, therefore, investigates reciprocal associations between sleep, mental strain, and training load by utilizing a prospective, observational design. In all, 56 junior endurance athletes were followed over 61 consecutive days. Unobtrusive, objective measurements of sleep with novel radar technology were obtained, and subjective daily reports of mental strain and training load were collected. The role of subjective sleep quality was investigated to identify whether the reciprocal associations between sleep, mental strain, and training load depended on being a good versus poor sleeper. Multilevel modeling with Bayesian estimation was used to investigate the relationships. The results show that increases in mental strain are associated with decreased total sleep time (TST, 95% CI = −0.12 to −0.03), light sleep (95% CI = −0.08 to −0.00), and sleep efficiency (95% CI = −0.95 to −0.09). Further, both mental strain and training load are associated with subsequent deceased rapid eye movement (REM, respectively, 95% CI = −0.05 to −0.00 and 95% CI = −0.06 to −0.00) sleep. Increases in TST, light, deep, and REM sleep are all associated with subsequent decreased training load (respectively, 95% CI = −0.09 to −0.03; 95% CI = −0.10 to −0.01; 95% CI = −0.22 to −0.02; 95% CI = −0.18 to −0.03). Finally, among poor sleepers, increases in sleep onset latency are associated with increases in subsequent mental strain (95% CI = 0.09–0.46), and increases in deep sleep are associated with decreases in subsequent training load (95% CI = −67.65 to 11.43). These results offer novel insight into the bidirectional associations between sleep, mental strain, and training load in athletes and demonstrate the detrimental effects of mental strain on sleep, likely caused by mental activation incompatible with sleep. An increased need for recovery, suggested by increased TST and time in different sleep stages, is associated with subsequent self-regulatory reduction of training loads by the athletes. In poor sleepers, increases in deep sleep may suggest an elevated need for physiological recovery.

Current Opinion in Pulmonary Medicine

“…Activity monitoring can be done nonobtrusive and with low costs using radar technology [ 16 ]. Since a couple of years, several engineering companies have developed radar technology devices which are placed on a bedside table and record the movements of the sleeping person [ 17 ]. These devices essentially derive the same signals as ballistocardiography: coarse body movements, respiration related movements, and the HR.…”

Section: Movement Recordingmentioning

confidence: 99%

Alternative algorithms and devices in sleep apnoea diagnosis: what we know and what we expect

Penzel

Fietze

Glos

2020

Purpose of review Diagnosis of sleep apnoea was performed in sleep laboratories with polysomnography. This requires a room with supervision and presence of technologists and trained sleep experts. Today, clinical guidelines in most countries recommend home sleep apnoea testing with simple systems using six signals only. If criteria for signal quality, recording conditions, and patient selection are considered, then this is a reliable test with high accuracy. Recent findings Recently diagnostic tools for sleep apnoea diagnosis become even more simple: smartwatches and wearables with smart apps claim to diagnose sleep apnoea when these devices are tracking sleep and sleep quality as part of new consumer health checking. Alternative and new devices range from excellent diagnostic tools with high accuracy and full validation studies down to very low-quality tools which only result in random diagnostic reports. Due to the high prevalence of sleep apnoea, even a random diagnosis may match a real disorder sometimes. Summary Until now, there are no metrics established how to evaluate these alternative algorithms and simple devices. Proposals for evaluating smartwatches, smartphones, single-use sensors, and new algorithms are presented. New assessments may help to overcome current limitations in sleep apnoea severity metrics. Video abstract .