A ZnO thin-film driven microcantilever for nanoscale actuation and sensing

Abstract

2013) A ZnO thin-film driven microcantilever for nanoscale actuation and sensing, Zinc oxide (ZnO) thin film as a piezoelectric material for microelectromechanical system (MEMS) actuators and sensors was evaluated. ZnO thin films were deposited using radio frequency (RF) magnetron sputtering. Process parameters such as gas ratio, working pressure, and RF power were optimized for crystalline structure. The ZnO thin films were characterized by X-ray diffraction (XRD) and scanning electron microscopy (SEM). Good quality of ZnO thin films was further confirmed by a high transverse piezoelectric coefficient d 31 . A microcantilever was then designed, fabricated, and characterized. Design formulas of resonant frequency, actuation, and sensing sensitivities were derived. The resonant frequency was determined by an impedance analyzer. Tip deflection on nanometer level was demonstrated with the cantilever used as an actuator. The actuation sensitivity was found to be 12.2 nm/V. As a sensor, the cantilever was calibrated against a reference accelerometer. The sensing sensitivity was characterized to be 46 mV/g. The characterization results were compared with design specifications. The differences were caused mainly by thickness control in etching. This study showed that ZnO is a promising piezoelectric material for MEMS actuators and sensors in terms of excellent process compatibility and good piezoelectric performance.

A Theoretical and Empirical Investigation of Design Characteristics in a Pb(Zr,Ti)O3-Based Piezoelectric Accelerometer

“…Unfortunately, all piezoelectric type accelerometers are basically a compromise between sensitivity and resonant frequency. To be specific, these two performance characteristics are fundamentally associated by a trade-off relation: namely, one property must increase at the sacrifice of the other [ 4 , 5 , 6 , 7 , 8 , 9 ]. In considering the possible presence of alternative designs of the sensor components, therefore, challenges always exist in seeking advanced sensor designs with improved performances related to these two characteristics.…”

Low-Frequency Vibration Sensor with a Sub-nm Sensitivity Using a Bidomain Lithium Niobate Crystal

“…The problem of the weak conversion of a mechanical deformation into an electrical signal by single-crystalline piezoelectric materials can be solved by utilizing complex constructions, such as unimorphs, bimorphs, or multilayer composites [27,28,29,30,31], but the presence of adhesive layers or grain boundaries in these composite transducers decreases the sensitivity, as well as the accuracy and thermal stability of the sensors. However, there is a way to manufacture a series bimorph for the piezoelectric sensing element and avoid bonding of separate plates by the formation of two domains with oppositely-directed spontaneous polarization vectors in a ferroelectric single-crystalline plate.…”

Study of Sensitive Parameters on the Sensor Performance of a Compression-Type Piezoelectric Accelerometer Based on the Meta-Model

“…One of the most important aspects of the sensor performance is sensitivity and resonance frequency. In general, there is a trade-off between the resonance frequency and sensitivity [3][4][5][6][7][8], such that a higher resonance frequency will provide a larger usable frequency range at the expense of reduced sensitivity.…”