Abnormal hole mobility of biaxial strained Si

Abstract

The strain effect on the hole mobility is investigated by bulk Si field-effect transistor, substrate-strained Si devices, and these devices under biaxial tensile mechanical strain. The hole mobility along < 110 > direction on (001) Si substrate degrades at small biaxial tensile strain (<similar to 0.3%) but enhances at the biaxial tensile strain larger than similar to 0.3%. This abnormal behavior can be understood in terms of the effective hole conductive mass which is the population average of heavy-hole and light-hole masses. The effective mass is more heavy-hole-like at small strain, since the heavy-hole band has a larger density of state than light-hole band. As the biaxial tensile strain increases, the hole population in the light-hole band increases due to the upshift and crossover of the light-hole band above the heavy-hole band. Therefore, the effective mass with larger biaxial tensile strain decreases significantly due to the small mass of light hole. The effective hole mass, which increases at small strain, then decreases at large strain, is responsible to the abnormal hole mobility behavior. (c) 2005 American Institute of Physics

Hole mobility of strained Si/(001)Si1−x Ge x

“…The simulation results about hole mobility at room temperature are consistent with the results of refs. [16,17] about inversion layer in stained silicon, all of which change non-monotonically with germanium content. At room temperature, the hole mobility is still lower than that of electron under the same strain conditions and impurity concentration [18], because ionized impurity scattering of hole varies with germanium content evidently due to the effect of both top band occupancy and density-of-state effective mass as Figures 1 and 2 show.…”

Elastically strain-sharing nanomembranes: flexible and transferable strained silicon and silicon–germanium alloys

“…Consequently much higher levels of strain are required to enhance the hole mobility. This effect is shown in figure 4(d) [7]; however, some reports indicate both a less dramatic degradation of hole mobility at low strain and an enhancement that begins at strains as low as 0.3% [40].…”

“…Unlike the electron mobility, the hole mobility is complicated by a warping of the valence band with strain. The effective mass initially increases with small amounts of strain, degrading the mobility [40]. With increasing tensile strain, the energy of the light-hole band is raised relative to that of the heavy-hole band and the mobility begins to demonstrate an enhancement as more holes are occupied in the light-hole band.…”

Residual Stress of Curvature Sapphire Substrate with GaN Film Released by the Application of Trench Structures

“…Strain is extensively used in the current semiconductor industry [1][2][3] including solar cell devices [4] and light-emitting diodes (LEDs) [5] because it can change material properties such as energy band structure [6], carrier effective mass [6], and radiative recombination rates [5]. One of the key stressors in the current industry is called an Epi-layer stressor [7].…”