Active Power and Reactive Power FRT Coordinated Control strategy of OffShore Wind Farms Connected to Power Grid with AC Cables

Tian, Xinshou; Li, Yan; Guo, Mei; Ye, Rong; Huang, Ruanming; Zhang, Mengyao

doi:10.1109/powercon.2018.8602131

Cited by 5 publications

(4 citation statements)

References 10 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The microprocessor has been used as an implementation tool in [3] and [14]. In addition, PSCAD/EMTDC software in [32], DIgSILENT/PowerFactory in [34], dSPACE ds1104 based system in [42], DigSILENT software in [46] and OPAL‐RT's eMEGASIM and ePHASORSIM [86], PSIM software [59, 63, 64, 67, 70], MATLAB and PSIM co‐simulation platform [71], ARM CORTEX processor [75], DlgSI LENT/PowerFactory [60]: FORTRAN programming language [92], MATLAB/Simulation [1, 2, 4, 31, 39, 45, 48, 49–58, 62, 65, 66, 68, 69, 72, 73–74, 77–85, 88, 91, 93–94, 96, 97, 99, 100–103, 107, 105, 106], software PSIM [89], DIgSILENT/PowerFactory [90], ETAP simulation platforms [29], DIgSILENT/PowerFactory [34], HiL tests in the PLECS settings [104], OPAL‐RT's eMEGASIM and ePHASORSIM [86], PSCAD/EMTDC [87] have been used as implementation tools.…”

Section: Analysis Of the Type Of Control Grid Code And Type Of Regsmentioning

confidence: 99%

“…Regrettably, with the growing need for renewable energy, this is no longer feasible to join or detach REGs whenever and wherever, since this would jeopardize the power stability and dependability of the power system [25][26][27][28]. As a result, grid codes [29][30][31][32][33][34] have included stringent criteria for REG grid integration. Moreover, the utility grid operators with considerable renewable energy penetration are concerned about reactive power control and voltage stability [35][36][37][38].…”

Section: Percent Of Total Power Generationmentioning

confidence: 99%

“…The suggested RP control model seems to be easy to develop and outperforms traditional current controllers. In 2018, Tian et al [34] looked at the RP constraints of off-shore turbines when voltages were dropped. Second, under grid failure conditions, the "voltage/power characteristics" of off-shore wind farms linked to the electrical grid using AC cables have been investigated.…”

Section: Hybrid (Wind and Solar) Systemmentioning

confidence: 99%

See 2 more Smart Citations

Reactive power control in renewable rich power grids: A literature review

Kumar¹,

Lakshmanan²,

Jaisiva³

et al. 2023

IET Renewable Power Gen

View full text Add to dashboard Cite

Recently, there is vast progress in the integration of renewable energy generators (REGs) into the power grid. The reactive power, which is indeed a fundamental power system factor is being influenced highly by the renewable power penetration levels. As a consequence, this has paved the way toward the generation of steady-state voltage and dynamic/transient stability issues. Therefore, to provide a sustainable and dependable power grid, it is indeed important to maintain and control adequate reactive power reserves. This study introduces a comprehensive literature survey on "management of reactive power in renewable-rich power networks". A total of 75 research publications have been collected for this study, and a concise summary of each article is offered. The articles are categorized according to the types of REGs used, type of control, grid code consideration, controller device, implementation tools, grid type, load type as well as various reactive power support systems. In addition, this study examines the advantages and drawbacks of existing models. The performance recorded in each of the collected papers are discussed. Ultimately, the most critical challenges related to management of reactive power in renewable-rich power grids are identified, along with some essential methodological suggestions for the electricity sector, regulators, and research scientists.

show abstract

Section: Analysis Of the Type Of Control Grid Code And Type Of Regsmentioning

confidence: 99%

Section: Percent Of Total Power Generationmentioning

confidence: 99%

Section: Hybrid (Wind and Solar) Systemmentioning

confidence: 99%

See 1 more Smart Citation

Reactive power control in renewable rich power grids: A literature review

Kumar¹,

Lakshmanan²,

Jaisiva³

et al. 2023

IET Renewable Power Gen

View full text Add to dashboard Cite

show abstract

“…The results were illustrated better performance in a fault condition rather than methods based on conventional controllers. A new control method for DFIG was established in Tian et al's 24 studies based on WECS. In this method, the reference of quadrature and direct current of the rotor side converter is calculated separately during the fault and post-fault conditions and applied to the controller and SVM system.…”

Section: Introductionmentioning

confidence: 99%

Improving fault ride through capability of induction generator‐based wind farm using static compensator during asymmetrical faults

khani

2021

Int Trans Electr Energ Syst

View full text Add to dashboard Cite

The growing trend of using wind turbines makes challenges to supply safe power to the power system. In fact, the fault ride through (FRT) capability of wind turbines is a serious phenomenon in their safe operation. In this paper, a new control method is proposed to improve the capability of wind farms in asymmetrical fault conditions. This method is based on releasing computed reactive power by the static compensator (STATCOM) to the grid during the fault to overcome the deep voltage of the point of common coupling (PCC). Although there are many studies to control wind turbines in fault condition using STATCOM, the main strength point of this study is the appropriate performance of the proposed system in asymmetrical faults. This feature is operated and simulated on 14 Bus standard grid to investigate the appropriate operation of a wind farm in a real grid. Also, by controlling the reactive power, preventing deep voltage collapse is achieved during the fault. Also, the wind turbine, STATCOM, and their control systems are formulated, modeled, and simulated in MATLAB/Simulink environment.

show abstract