Advantage to Short Circuit Current of Calculation on Power System by the MVA Method

Abstract

<jats:p>The short circuit current of the equipment must be carefully calculated. If it is not effective to isolate the fault point, while the system is abnormal. That will leads to prolonged fault time and the instability of power system. The calculation process is very so complicated that must to establish any capacity of equipment on system. This article will introduce method of the traditional algorithm beginning. Next, to establish the basic principles of simplified procedures such as the capacity of two parallel devices are considered as a series method (plus), but the capacity of two series devices are considered as a parallel method to calculate. Finally, to calculate the fault short-circuits current based on the actual equipment capacity on the power system. Another technique is to transform the structure of transmission line from △ to Y so that it easy to simplify for calculation. It is proved to be a simple and easy to understand what method for short circuit fault current of calculation. The method can provide accurate and effective calculation of system short circuit capacity and current at each equipment point, so that designer can make appropriate specifications in design and procurement to avoid wasteful investment.</jats:p>

Discussion and Improvement on the Calculation of the Relationship between the Base Emitter of the Bipolar Junction Transistor and the Temperature by Using MATLAB Software

“…Reference [1] is the Shockley theory, [2] and [3] are the explanations and application instructions of the basic textbooks of bipolar junction transistors; As for [4] and [5] are related to MATLAB software application reference and the examples in the textbooks [6,7] are based on the theoretical integration and application of actual transistor amplifier circuits are the blueprints for calculation and design. In [8], the author had introduced that the junction temperature estimation is obtained by the negative thermistor under dynamic conditions.…”

Design Standardized Program to Calculate the Related Data from Single Load on Single Feeder

“…A standardized computer program was developed to replace manual calculations for the purpose of this article, following referring to related power system books and journal articles. These Articles are been published in the international journal of Asian Journal of Research in Computer Science -such as literatures [1,2,3] describe what the MATLAB application software how to be used the calculation of power system equipment. So these important documents are included into this paper.…”