Aeroelastic Properties of Closely Spaced Modes for a Highly Loaded Transonic Fan

Abstract

In the design of modern compressor blades of wide chord (low aspect ratio) type it is often hard to avoid having modes that are close to each other in frequency. Modes which are closely spaced can interact dynamically. Mistuning and localization of stresses are known problems with this. A potential problem with this is also the possibility of coalescence flutter of the modes. Even if the modes are frequency separated at zero rotational speed, the centrifugal stiffening may cause the modes to attract and even cross (or veer) at some rotational speed. In design, mode separation criteria are sometimes applied in order to minimize the risk of encountering unknown dynamic phenomena. This study is performed to better understand the dynamics of closely spaced modes with respect to risk for coalescence flutter. A reduced order aeroelastic system is then constructed that describes the interaction between the different modes. The aeroelastic couplings are then calculated for the 2 mode system. The method is general in terms of mode shapes and number of interacting modes. A parametrical study is performed in order to study how strongly the modes interact when the frequency separation is decreased and if there is a risk of destructive coalescence flutter. The investigation is performed on a high pressure ratio front stage fan blade. The tendency of the modes to interact depends on the strength of the coupling compared to the strength of the pure structural modes. The tendency towards instability was increased in cases where the stability margin was smaller of the single modes. The results can be considered to support a separation criterion of 2% for the lower. A re-evaluation should be considered if lighter blade material and increased loads are to be used.

Prediction of Turbomachinery Aeroelastic Behavior From a Set of Representative Modes

“…However, these approaches are most suitable when no interaction between the mode families is present, or when the mode-shapes of the blades are fairly similar to the original tuned in-vacuo case. Previous studies [6][7] have shown that when two blade mode families interact (e.g. bending and torsion interaction), the aerodynamic damping predicted can be of considerable difference as for the one predicted for a single mode family.…”