Aerosol morphology and particle size distribution in orthopaedic bone machining: a laboratory worst-case contamination simulation. Is high-speed bone machining potentially harmful by pollution and quality schemes and what measures could be taken for prevention?

Abstract

Aim of the study High-speed bone machining devices with irrigation fluid were used in surgery to spread aerosols and toss tissue particles of varying morphology into the operating room. Based on measurements taken on a phantom object, the shape, size, and spatial contamination distribution of such particles were assessed. Method Cadaveric femoral heads were continuously machined with a spherical bur, manually held at a fixed attack angle. The irrigation fluid used during bone machining was enriched with bacteria to act as a tracer to quantify the spatial contamination. A vertical board equipped with snippets served as a phantom object to assess contamination load and morphology of airborne particles. Results Eight-nine percent of the particles had a non-circular cross section. The detected particle size ranged across six orders of magnitude, from 0.006 to 4 mm2 with a median particle size of 0.125 mm2. The CFU counts observed after the standard machining time ranged from 7 to 240, with a median of 2 CFUs. The highest median contamination was seen at the upper right corner of the phantom. Discussion The experiments show that contaminating particles of a wide variety of shapes and sizes are part of the aerosol created by high-speed burring. While protection of personnel and equipment is always important, surgical helmets should be worn, especially at contamination hotspots, and gloves should be replaced at the end of machining. Sensitive instruments and measuring devices—such as optical sensors—should also be protected effectively, as the optical measurement may be obstructed by aerosol particles.