Aging property of unimodal failure rate models

Jiang, Renyan; Ji, Ping; Xiao, Xu

doi:10.1016/s0951-8320(02)00175-8

Cited by 88 publications

(36 citation statements)

References 8 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The failure rate function is unimodal, and can be effectively viewed as increasing when r l < 0.8, constant when r l 2 ð0:8; 1:0Þ and decreasing when r l [ 1 [9].…”

Section: Lognormal Distributionmentioning

confidence: 99%

Distribution Models

Jiang

2015

Springer Series in Reliability Engineering

View full text Add to dashboard Cite

“…The failure rate function is unimodal, and can be effectively viewed as increasing when r l < 0.8, constant when r l 2 ð0:8; 1:0Þ and decreasing when r l [ 1 [9].…”

Section: Lognormal Distributionmentioning

confidence: 99%

Distribution Models

Jiang

2015

Springer Series in Reliability Engineering

View full text Add to dashboard Cite

“…In an effort to quantify the extent of ageing, Jiang et al (2003) proposed a measure called the ageing intensity function defined as…”

Section: Stochastic Orderingmentioning

confidence: 99%

Some results on an additive hazards model

Nair

Sankaran

2010

Metrika

View full text Add to dashboard Cite

show abstract

“…Statistical analysis and modeling based on data collected by means of accelerated ageing tests has been done in different fields of science and engineering [7][8][9][10][11][12].…”

Section: Lifetime Modelingmentioning

confidence: 99%

Modeling and optimization of membrane lifetime in dead-end ultra filtration

Zondervan

Roffel

2008

Journal of Membrane Science

View full text Add to dashboard Cite

a b s t r a c tIn this paper, a membrane lifetime model is developed and experimentally validated. The lifetime model is based on the Weibull probability density function. The lifetime model can be used to determine an unambiguous characteristic membrane lifetime. Experimental results showed that membrane lifetime shortens if the average membrane fouling status increases. The lifetime modeling results are then used to determine the economic lifetime of membranes. Subsequently, the economic lifetime of a membrane is used to optimize membrane lifetime, i.e. minimizing the total costs. Based on the experimental results it can be concluded that the total costs are minimal if the average membrane fouling status is approximately 1.7× the membrane resistance.

show abstract

Aging property of unimodal failure rate models

Cited by 88 publications

References 8 publications

Distribution Models

Distribution Models

Some results on an additive hazards model

Modeling and optimization of membrane lifetime in dead-end ultra filtration

Contact Info

Product

Resources

About