Al-Si-Zn Behaviouron Interface of AR500 Steel and AA7075 Aluminium Alloy BrazedJoint

Abstract

The brazing of steel and aluminium alloy using low melting point aluminium based fillers has been extensively studied and the technique has been used in many industries, especially the automotive industry. The strength and failure mode of AR500 steel and AA7075 aluminium alloy brazing joint using the Al-Si-Zn filler metal will be measured and calculated in this paper. However, the adverse effect of intermetallic phases formation on the joint strength has limited the application of this joining method.These dissimilar metals possessing a high strength joint would be of benefit to industry especially in reducing the weight of products. The torch brazing method using Al-Si-Zn base filler metal wasused to join AR500 steel and AA7075 aluminium alloy in this study. The intermetallic phase formation of the brazing on was investigated by scanning electron microscopy and the mechanical strength of the joints was evaluated by shear testing, flexural testing and low velocity impact testing. A maximum shear load of 6460 N was obtained. The presence of intermetallic phases was found to have some effect on the strength of the brazed joint. However, overall, this brazing process using Al-Si-Zn filler metal facilitates the joining of these dissimilar metals to improve the mechanical properties of the joint